Manual

33
IMPORTANT
The bathroom fan heater should preferably - especially when used in damp rooms - be
permanently installed on an electrical connection.
This connection may only be made by an authorised electrician and is therefore not
described further here.
For safety reasons, these operating instructions assume that the unit is used with a plug.
Passages about the connector do not apply in the case of a fixed connection.
Inserting / replacing the batteries in the remote control
Open the battery cover on the underside of the remote control, press the buckle on the battery
cover inwards and pull it out, remove the battery fuse strip. Please pay attention to the correct
polarity (+/-).
To replace the battery, please follow the steps below:
1. open the battery cover on the bottom of the remote control, press the buckle on the battery
cover inwards and pull it out, remove the old battery.
2. please ensure correct polarity (+/-) Use only type CR2025 and dispose of the old batteries in
an environmentally friendly manner and in accordance with the regulations in your country.
3. Slide the battery cover on the bottom of the remote control back into the remote control.
4. Be careful not to bend the contacts. Insert the new battery and close the battery compartment
cover.
NOTE
If you do not use the remote control for a longer period of time (4 weeks or longer), remove the
batteries from the remote control.