Datasheet

Product Specification
www.shuttle.eu
Shuttle Computer Handels GmbH
Fritz-Strassmann-Str. 5
25337 Elmshorn | Germany
Tel. [phone]
Fax [phone]
[e-mail]
Pa
g
e 13
|
16 October 2014
© 2014 by Shuttle Computer Handels GmbH (Germany). All information subject to change without notice. Pictures for illustration purposes only.
[1] Power on after power fail:
The BIOS setup provides a "Power-On after Power Fail" function that can be found under "Power Management
Configuration". As the name indicates, this function determines the PC's behaviour after power failure: (1)
unconditional power on, (2) restore former status or (3) keep system turned off. As a matter of the nature of this
function, it may fail after short power failures. This is why the XH97V also comes with a hardware-based solution. By
removing Jumper 4 (on the mainboard near the "Shuttle" imprint), the system will start unconditionally once power is
supplied.
[2] Optional D-Sub/VGA connector
The mainboard features one analog graphics connector. This 15-pin D-Sub VGA connector can be lead to the outside
of the backpanel by using the optional adapter PVG01. However, you can use not more than two displays at the
same time.
[3] mini-SATA (mSATA)
mSATA, not to confuse with "micro SATA", is a newer industry standard that converts the electrical SATA interface
(1.5 or 3.0 Gbit/s) to the physical "Mini PCI Express" mini card form factor.
[4] Optional Wireless LAN module:
This Slim PC supports an optional WLAN module which consists of a half-size Mini-PCIe card with IEEE 802.11n
functionality and an external antenna with an appropriate antenna cable. Shuttle offers a suitable accessory kit "WLN-
S" with two antennas to increase WLAN range.
[5] 4K Ultra-HD resolution
A 4K-display with Ultra-HD resolution (3840 x 2160) should be connected via DisplayPort, as only this port supports a
higher refresh rate of 60Hz. Certain displays (e.g. Dell UP2414Q) however require MST mode (Multi-Stream Transport)
to be enabled which sends two separate images at half resolution each to the display. These two images are then
combined and put in correct order by the Intel graphics driver when in Collage mode. Please note that HBR2-
mode (High Bit Rate 2) must be supported by each display to have two of them run at 4K resolution.
The video playback performance depends on the video format, bit rate and the processor used. Daily office
applications usually won't require the system to run under full load, however for smooth 4K (2160p) video playback
requirements are different. An Intel Core i3 processor or higher is recommended here, since the performance of
the integrated graphics engine of a Celeron or Pentium processor might not suffice.
[6] Optional accessory: Drive bay cover
If the XH97V is used without an optical slimline drive, this cover helps close the open bay which can be particularly
important in public institutions and prevent from dust and objects being inserted inappropriately. Please contact
Shuttle for the optional accessory "Mylar POI-MY01".
[7] Caution: for high ambient temperature over 40°C we strongly recommend to use SSDs instead of hard disk
drives.
[8] The optional accessory PHD4 allows for installation of one 3.5" hard drive. However doing so means no other
drives such as a slimline DVD drive or a 2.5" HDD/SSD can be used.