Owner's Manual

English

Hard Disk Write Protect

Set this option to protect the hard disk drive from being overwritten.

The Optimal and Fail-Safe default setting is Disabled.

Disabled:Set this value to allow the hard disk drive to be used normally. Read,

write, and erase functions can be performed to the hard disk drive. This is the

default setting.

Enabled:Set this value to prevent the hard disk drive from being erased.



The choice: Enabled, Disabled.

IDE Detect Time Out (Sec)

Set this option to stop the AMIBIOS from searching for IDE devices within the

specied number of seconds. Basically, this allows you to ne-tune the settings

to allow for faster boot times. Adjust this setting until a suitable timing that can

detect all IDE disk drives attached is found.

The Optimal and Fail-Safe default setting is 35.



The choice: 0, 5, 10, 15, 20, 25, 30, 35.

Different IDE disk drives take longer for the BIOS to locate than others do.