Datasheet

Product Specification
www.shuttle.com
Shuttle Computer Handels GmbH
Fritz-Strassmann-Str. 5
25337 Elmshorn | Germany
Tel. [phone]
Fax [phone]
[e-mail]
Pa
g
e 9
|
16
F
ebruar
y
2010
© 2009 by Shuttle Computer Handels GmbH (Germany). All Information subject to change without prior notice. Pictures for illustration purposes only.
Shuttle X50V2 Barebone Installation Instructions
As a barebone, the device is delivered
without memory and hard drive. Please
note the following when installing or
removing certain components. The device
features two SO-DIMM slots for a maximum
capacity of 2x 2GB DDR2-667/800 memory
and one 2.5 inch drive bay for one S-ATA
hard disk.
Please note and proceed as follows:
a) Only authorized and skilled personnel
must intervent
b) Improper handling might damage the
device which is not covered by warranty
c) To avoid damage of electronical
components by electrostatic discharge
(ESD), ensure that the static electricity of
your body is diverted permanently before
you touch electronical components. Use
an earthing wrist strap and an anti-static
ground mat, if possible.
(0) Put the device on a soft cloth with the
display facing downwards or use the white
pouch the device was delivered in.
(1) Disconnect the device from the mains
and put it on a soft base with the display
facing downward and fold the stand
vertically upward. Next, carefully remove
the cap with the Shuttle logo that is clicked
into place by six hooks. Carefully press the
side of the cap with your fingertips to
loosen it. Otherwise the cap can be
loosened using a plastic card.