Instructions

Product Specifications
w w w . s h u t t l e . e u
Shuttle C omputer Handels G m bH
Fr itz -Stra ssma nn- St r . 5
25337 Elmshor n | German y
Tel. [phone]
Fax [phone]
E- Mail: s ales@ sh utt le. eu
Page 9 | 25 October 2019
© 2019 by Shuttle Computer Handels GmbH (Germany). All information subject to change without notice
. Pictures for illustration purposes only.
Audio
Realtek ALC269 Audio Codec
Two analog audio connectors (3.5 mm) on the bottom side:
1) Line-out (headphones)
2) Microphone input
Digital Audio is supported via HDMI.
Wired
Network
Intel i211 Ethernet Controller with MAC, PHY and PCIe interface
Supports 10 / 100 / 1.000 MBit/s operation
Supports WAKE ON LAN (WOL) from S3, S4 modes
Supports network boot by Preboot eXecution Environment (PXE)
Wireless
Network
Model: AzureWave AW-CB209NF
Chipset: Realtek RTL8821CE
M.2-2230 (NGFF) expansion card
Connected with two internal antennas (via IPEX4)
Supports WiFi IEEE 802.11b/g/n/ac in the 2.4/5 GHz band, 1T1R
Max. 72.2 / 150 Mbps using 20 / 40 MHz bandwidth in n-mode
Max. 433.3 Mbps using 80 MHz bandwidth in ac-mode
Supports Bluetooth 4.2 in the 2.4 GHz band (BT 4.0 under Linux)
Front LEDs
Power LED (blue)
Hard disk LED (orange)
Battery LED (red)
Connectors
left side
Power button
2x USB 3.1 Gen. 1 (= USB 3.0, max. 5 Gb/s)
SD card reader
Hole with power button
Connectors
bottom side
HDMI 1.4b (supports digital video and digital audio)
VGA connector (D-Sub 15 pol., analog video)
2x USB 3.1 Gen. 1 (= USB 3.0, max. 5 Gb/s)
2x USB 2.0
2x COM/serial (D-Sub)
Gigabit Network (LAN, RJ45)
Audio Line-out / headphones (3.5 mm jack)
Microphone input (3.5 mm jack)
DC input for external power adapter (5.5 / 2.5 mm)
2x Perforation for optional WLAN/LTE antennas (diameter: 7 mm)
Connectors
onboard
Internal USB 2.0 type A connector for a USB stick
Serial ATA (6 Gbps) data/power combo connector
3x USB 2.0 header (all occupied)
Microphone connector (2-pin, occupied)
Speakers connector (4-pin, occupied)
eDP connector (Embedded DisplayPort) - occupied by the display
LPC connector (occupied)
I2C connector for optional NFC accessory
CMOS battery connector (2-pin occupied)
System battery connector (14-pin, battery is optional)