Datasheet
Product Specifications
www.shuttle.eu
Shuttle Computer Handels GmbH
Fritz-Strassmann-Str. 5
25337 Elmshorn | Germany
Tel. +49 (0) 4121-47 68 60
Fax +49 (0) 4121-47 69 00
sales@shuttle.eu
Pa
g
e 11 23 Ma
y
2014
© 2014 by Shuttle Computer Handels GmbH (Germany). All information subject to change without notice. Pictures for illustration purposes only.
[3] Integrated video outputs (HDMI and DisplayPorts): Not all LGA1150 Intel processors may support integrated
graphics. Please check the specification of the used processor. If you want to use the video outputs, then please
make sure that the used processor has integrated graphics.
[4] Teaming Mode
The teaming function allows you to group both available network adapters together to function as a single adapter
- a method of creating a virtual LAN. The benefit of this approach is that it enables load balancing and failover.
[5] Optional Wireless LAN module:
This Slim PC supports an optional WLAN module in the form of a half-size Mini-PCIe card with IEEE 802.11n
functionality and an external antenna with appropriate antenna cable. Shuttle therefore offers a suitable
accessory kit "WLN-S" with two antennas.
[6] mini-SATA (mSATA)
is a newer industry standard which converts the electrical SATA interface (1.5 or 3.0 Gbit/s) to the pysical "Mini PCI
Express" mini card form factor. Not to be confused with the "micro SATA" connector.
[7] Caution: for high ambient temperatures over 40°C we strongly recommend to use SSDs (supporting at least
70°C) and rugged SODIMM memory with a wider temperature range (up to 95°C).
[8] Power on after power fail:
The BIOS setup provides a "Power-On after Power Fail" function that can be found under "Power Management
Configuration". As the name indicates, this function determines the PC's behaviour after power failure: (1)
unconditional power on, (2) restore former status or (3) keep system turned off. As a matter of the nature of this
function, it may fail after short power failures. This is why the DS81 also comes with a hardware-based solution. By
removing Jumper 4 (to be found on the mainboard besides the hard disk LED) the system will start unconditionally
once power is supplied.
[9] Optional D-Sub/VGA connector
The mainboard features one analog graphics port. This 15-pin D-Sub VGA connector can be lead to the outside of
the backpanel by using an optional adapter PVG01. However doing so means one serial port (COM) less can be
used at the backpanel.
Shuttle Slim PC Barebone DS81 – Required Components
The following components need to be added to make it a fully-configured Mini PC:
2.5” SATA hard disk
or Solid State Disk (SSD)
(max. 12.7 mm height)
Up to two DDR3-1333/1600
SO-DIMM memory modules
max. 8GB each
Windows / Linux
Operating System
LGA1150 processor
TDP max. 65W
Core i7 / i5 / i3, Pentium
or Celeron
Optional:
WLAN-Accessory WLN-S
Optional:
mSATA SSD storage










