Owner's Manual
17
English
Type a maximum of 6-digit password and press [Enter]. The password typed now will
replace any previously set password from CMOS memory. You may also press [ESC]
to abandon new password setting.
When the Supervisor Password is set, new items Change User Password and Pass-
word Check will be added in the menu.
Select Change User Password to give or to abandon password setting same as
Change Supervisor Password item above.
Note that Supervisor Password eld allows users to enter and change the settings of
the BIOS SETUP UTILITY, while User Password eld only allows users to enter the
BIOS SETUP UTILITY without having the authorization to make any change.
Setup
The password is required only when users try to access to
BIOS SETUP UTILITY.
Always
The password is required every time when the Notebook is
powered on or when users try to access to BIOS SETUP
UTILITY.
The Password Check item is used to specify the type of BIOS password protection
that is implemented. Settings are described below:
To clear a set Supervisor Password/ User Password, just press [Enter] under Change
Supervisor Password/ Change User Password eld when you are prompted to enter
the password. Please note that when Supervisor Password has been cleared, User
Password will be cleared as well. A message box will pop up conrming password will
be disabled. Once the password is disabled, the system will boot and user can enter
setup without entering password.