Specifications

External Effects DeviceIMono Sound
ReinforcementISingle Master Control (See Setup 6.)
Connect the EFFECTS OUTPUT jack to the input of
the external effects device (echo, flanger, etc.),
and the effects device output to a channel 7 or 8
AUX INPUT jack. Adjust the channel 7 or 8 PAN pot
to center. Patch the A EQ OUTPUT jack to the B PA
INPUT jack. Both power amplifiers are fed by the
channel A MASTER and graphic equalizer, and
both SPEAKER OUTPUTS provide the same
signal at 200 watts to
4 ohms.
Separate Monitor Equalizer and
Power Amplifier
(See Setup 7.)
When the A and B SPEAKER OUTPUTS are in use
(and each requires its own graphic equalizer) and
a separate monitor system is desired, connect the
MONITOR OUTPUT jack to the input of a separate
equalizer (such as a Shure
SR107). Connect the
equalizer output to a separate power amplifier
(such as a Shure
SR105B) and connect monitor
speakers. The monitor system is only affected by
the PRO MASTER INPUT
ATTEN, MONITOR, and
MONITOR MASTER controls.
Biamplification (See Setup 8.)
To provide a monophonic biamped output to
two-way speaker systems such as the Shure 701,
connect the B EQ OUTPUT to the input of an
electronic crossover (such as the Shure
SR106).
Connect the crossover high-frequency output to
the channel A PA INPUT, and the low-frequency
output to the channel B PA INPUT. Connect the
SPEAKER OUTPUTS A to the speaker
high-frequency input jack and the SPEAKER
OUTPUTS B to the speaker low-frequency input
jack. (Refer to the speaker system data sheet for
biamping modification instructions.)
Note that the output channel A MASTER and
graphic equalizer are not operative; the channel B
MASTER and graphic equalizer adjust the output
signal to the speakers.
SPEAKE
OUTPUT-
-.
I
A EQ OUTPUT
.. 0..
EFFECTS
TO CHANNEL
7 OR 8
AUX INPUT
EXTERNAL EFFECTS DEVlCEiMONO SOUND
REINFORCEMENTiSlNGLE MASTER CONTROL
SETUP
6
MAIN
WPEA3
I MONITOR
SPEAKtn
OUTPUTS I
SEPARATE MONITOR EQUALIZER
AND POWER AMPLIFIER
SETUP
7
A PA INPUT
.. .*,
BlAMPLlFlCATlON
SETUP 8