General Description Shure Sound Isolating™ Earphones, deliver a detailed soundstage free from outside noise. The powerful and stylish Shure SE earphones come with a detachable cable, adapters, a durable carrying case, and interchangeable Sound Isolating sleeves for a comfortable and personalized fit. Wearing the Earphones The following are some suggested ways of wearing the earphones.
Wear the cable over the ear and secure it behind the head to help keep the earphones in place during physical activity. Tighten the cable and take up slack by raising the cable cinch. Detachable Cable You may need to detach the cable from the earphones to attach optional components or to replace the cable if it becomes damaged. To prevent accidental separation, the connector has a snug fit. Take special care to prevent damage to the earphone and connector. Do not use pliers or other tools.
Inserting the Earphones Insert the earphones so they form a tight seal. The fit of the earphone can greatly affect sound quality.
Important: If there seems to be a lack of low frequency response (bass), this means that the earphone sleeve is not forming a tight seal. Gently push the earphone deeper into the ear canal or try a different sleeve.
Warning: Do not push the earphone sleeve beyond the ear canal opening. Changing Sleeves Twist and pull to remove the sleeve from the nozzle. Slide on a new sleeve so that it completely covers the barb and the nozzle. Caution: If the barb or any of the nozzle is exposed, the sleeve is not properly installed. Replace sleeves if they do not tightly grip the nozzle. To ensure proper fit and performance, use only sleeves supplied by Shure (unless using custom molded sleeves).
Note: Do not pull on cable to remove earphone.
Select an earphone sleeve that provides the best fit and sound isolation. It should be easy to insert, fit comfortably, and easy to remove. Soft Flex Sleeves: In small, medium, and large sizes. Made from pliable rubber. Soft Foam Sleeves: Compress the foam sleeve between your fingers and insert into the ear canal. Hold in place for about ten seconds while the foam expands. Triple-Flange Sleeves: If desired, use scissors to trim the stem on the sleeve.
To clean sleeves, remove them from earphones, gently rinse in warm water and air dry. Foam sleeves require a longer drying time. Inspect for damage and replace if necessary. Ear sleeves must be completely dry before reusing. Wipe the earphones and sleeves with mild antiseptic to avoid infections. Do not use alcohol-based disinfectants. Do not expose earphones to extreme temperatures. Replace sleeves if they do not fit properly. Do not attempt to modify this product.
Caution: When cleaning, do not force any object through the earphone nozzle! This will damage the earphone sound filter. Warning: The cleaning tool is only to be used to clean the earphones. Any other use, such as using the tool to clean ears or foam sleeve, could result in injury. The cable connectors to the earphones may collect debris or other deposits that can affect audio quality. If this happens, disconnect the cables and clean them using a dry cotton swab.
Specifications Transducer Type Single High-Definition MicroDriver Sensitivity at 1 kHz 107 dB SPL/mW Impedance at 1 kHz 17 Ω Frequency Range SE215 Special Edition 21 Hz–17.5 kHz SE215 22 Hz–17.5 kHz Net Weight 30 g (1 oz.) Accessories For information about earphone accessories and other Shure products visit: www.shure.com Furnished accessories subject to change. Certifications This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking.
Authorized European representative: Shure Europe GmbH Headquarters Europe, Middle East & Africa Department: EMEA Approval Jakob-Dieffenbacher-Str. 12 75031 Eppingen, Germany Phone: 49-7262-92 49 0 Fax: 49-7262-92 49 11 4 Email: info@shure.
