User Guide

Storage Temperature
-29°C to 74°C (-20°F to 165°F)SE535
-29°C to 74°C (-20°F to 165°F)SE425
-29°C to 74°C (-20°F to 165°F)SE315
-10°C to 50°C (14°F to 122°F)SE215-BT1
-10°C to 50°C (14°F to 122°F)SE112-BT1
Bluetooth Specifications
Antenna Information
• Type = Chip
• Gain = +2.13 dBi
Bluetooth 4.1
• Operating frequency = 2402MHz-2480MHz
• Modulation scheme = FHSS
• RF power = +5.38dBm (E.I.R.P.)
BT1 Battery Specifications
Battery Type
Rechargeable Li-Ion
Nominal Voltage
3.7 V DC
Battery Life
up to 8 hours
Charging Requirements
USB Source
5 V DC, 100 mA, minimum
Battery Charging Temperature Range
0 to 45 °C (32 to 113 °F)
Safety Information
WARNING
• Follow instructions from manufacturer.
• Product battery may explode or release toxic materials. Risk of fire or
burns. Do not open, crush, modify, disassemble, heat above 140°F
(60°C), or incinerate.
• Attention should be drawn to the environmental aspects of battery dis-
posal.
• Product shall not be exposed to excessive heat such as sunshine, fire,
or the like.
• Do NOT make unauthorized alterations to this product.
WARNING: This product contains a chemical known to the State of California
to cause cancer and birth defects or other reproductive harm.
Note: Battery replacement to be performed only by Shure authorized service
personnel.
CAUTION: Follow applicable laws regarding mobile phone and headphone
use while driving.
This product contains magnetic material. Consult your physician on whether
this might affect your implantable medical device.
Information to the user
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC Part 15.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation of this device is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent
appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes
: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est sus-
ceptible d'en compromettre le fonctionnement.
Note: Testing is based on the use of supplied and recommended cable types. The use of other than shielded (screened) cable types may degrade EMC perfor-
mance.
Shure IncorporatedEarphone Resource Center Shure Earphones
2017/10/066/8