User Manual

SCM800 REAR PANEL

MODEL SCM800/E REAR PANEL

FIGURE 2

SCM800: 120 VAC Power Connector and Rocker Switch: 11.

Switch turns unit on when power cord is plugged into 120 Vac.

SCM800E: 230 VAC Power Connector and Rocker Switch:

Switch turns unit on when power cord is plugged into 230 Vac.

DIP Switch: 12. The 7-position DIP switch provides control of the

output limiter threshold (see DIP Switches).

LINK IN/OUT Jacks: 13. Permit multiple SCM800 mixers to be

stacked for additional inputs.

LINE OUTPUT Removable Block Connector:14. Active balanced

line-level signal for connection to amplifiers, recorders or other

mixers. If necessary, output level can be changed to microphone

level. Refer to the Internal Modications section of this manual.

SEND/RECEIVE ¼-inch Insert Jacks:15. Post-fader, post-EQ insert

point to add external compressor/limiter, graphic or parametric

EQ, or other signal processors. Tip is send, ring is return. Can

be modified for use as a Direct Out (see InternalModications).

AUX/INS/INS 3-Position Slide Switch:16. Selects either aux input

function or insert function for channel 8 (only) Insert jack. Left

switch position is AUX IN; center and right positions are INSERT.

This switch is located behind Line Output connector.

INPUT 1-8 Removable Block Connectors:17. Active balanced

microphone- or line-level inputs.

Input 1 - 8 MIC/PHM/LINE 3-Position Slide Switch: 18. Selects

operation at either microphone-level (left), microphone-level with

48 V phantom power (center), or line-level (right) signals. This

switch is located behind the removable block connector.