Troubleshooting guide

Control Pins
SHURE

P4800 System Processor Software Guide Page 77 of 108
The Control Pins Window
The Control Pins window is an interface for both configuring control pins globally at the device level, and
assigning processors to controllers specifically for each preset. Access this window by selecting the
[Devices>Control Pins Configuration] menu command from the main window.
Configuration Views
The Control Pins window has two configuration views: Control In and Logic Out. To switch between the
two views, click on either the [Control In] or [Control Out] text or on the corresponding pin connectors,
depending on which set of pins you wish to configure. Figure 50 shows the [Control In] view.
CONTROL IN
Use this view to configure and map the control input pins to perform any of the following functions via
external hardware:
§ Switch between presets stored in the device.
§ Mute and un-mute channels.
§ Adjust gain levels.
LOGIC OUT
Use this view to configure and map the logic output pins to indicate any of the following conditions to
external displays or devices:
§ The preset number of the active preset.
§ The mute status of any input or output channel.
Preset Encoding Parameter Settings
These parameter boxes appear next to the [Control In] and [Logic Out] text in the upper part of the
Control Pins window. The combined settings in these boxes dictate the configuration of the preset
control block. Enter the number of presets first, then select an encoding type.
Figure 50 -- Control Pins Window: "Control In" View