Troubleshooting guide

Modular Processors
SHURE

P4800 System Processor Software Guide Page 70 of 108
Keyboard Controls
You can use the following keyboard controls to make fine adjustments to the currently selected filter.
Keystroke Result
←
Decreases frequency by one screen pixel
→
Increases frequency by one screen pixel
↑
Increases gain by 0.5 dB
↓
Decreases gain by 0.5 dB
SHIFT with ←
Decreases frequency by 1/3 octave
SHIFT with →
Increases frequency by 1/3 octave
CTRL with ←
Decreases the bandwidth of a filter point by small increments
CTRL with →
Increases the bandwidth of a filter point by small increments
SHIFT with ↑
or PAGE UP
Increases gain 3 dB
SHIFT with ↓
or PAGE DOWN
Decreases gain by 3 dB
SPACEBAR
or right mouse click
Sets gain to 0 dB
Note: Nudging the frequency by one pixel changes the value by approximately 1/100 of
an octave, or 1%.
Copy, Cut and Paste
Filter points can be copied, cut and pasted between parametric EQ windows, given the following
considerations:
§ There are a sufficient number of available filter points in the parameter window where you
are pasting.
§ Cut/Shelf filter settings can only be copied and pasted between PEQ+CS processors.
Note: The Cut command is not available for cut/shelf filter handles.
To copy and paste filters:
1. Click to select a single filter, or select multiple filters using one of the following methods:
§ CTRL+Click.
§ Use the [Edit>Select All] menu command.
2. Select the [Edit>Copy] menu command.
3. Open the parameter window of the parametric EQ where you wish to paste filter settings.
4. Select the [Edit>Paste] menu command.
Note: When filters are part of a multiple selection, they are highlighted in pink and their
parameter settings are locked. To de-select from a multiple selection, click on
any control in the parameter window, or on a filter outside the selection area.