Troubleshooting guide

Creating a Configuration
SHURE

P4800 System Processor Software Guide Page 21 of 108
To add multiple processor blocks:
1. C
TRL+Click to select multiple empty slots.
2. Use the right-click contextual menu to place the same type of processor in every
selected slot.
- OR -
3. Use the [Processor>Add] option on the main menu bar.
Stereo Processors
Stereo processors are placed in the signal flow diagram in much the same way as the other modular
processor blocks. However, each of the stereo channels appears as a separate block. Double-clicking
on either block will open the parameter window for both channels.
Each of the following dynamic processors will operate as a stereo pair:
Block Name Description
§ ST COMP Stereo Compressor
§ SFT ST COMP Stereo Compressor − Soft Knee Option
§ ST LIM Stereo Limiter
§ SFT ST LIM Stereo Limiter − Soft Knee Option
To add a stereo processor block from the Processor Toolbox:
1. Click on a processor block
When you select a stereo processor from the Processor Toolbox, the cursor will appear somewhat
differently than it does for other processors, as pictured in the following table.
Location where the first channel of
the stereo processor can be placed.
Location where the second channel of
the stereo processor can be placed.
2. Add the first channel of the stereo pair.
§ Click and hold the left mouse button to drag a processor block from the Processor
Toolbox to the signal flow diagram. Release the mouse button to place the first processor
channel at the current cursor location.
- OR -
§ Click once on a processor block in the Processor Toolbox, then click again on the
appropriate empty slot in the signal flow diagram.
3. The cursor changes to indicate you must place the second channel of the processor.
§ Click on the appropriate slot to add the second stereo channel.
To add a stereo processor using the menu:
1. C
TRL+Click to select empty slots on two different channels.
2. Use the right-click contextual menu to place both channels of the stereo pair.
- OR -
3. Use the [Processor>Add] option on the main menu bar.