Troubleshooting guide

Start-Up Guide

SHURE



P4800 System Processor Software Guide Page 15 of 108

ure 9

−

Preset Information Dialo

9. Name the Preset

Click once with the left mouse button anywhere in the

information box in the center of the control bar to open the

Preset Information dialog, as pictured on the right in figure

9. Enter a name for the preset, up to 15 characters long,

and a description, then click [OK]. For more information,

refer to the

Naming a Preset or Scene File section on

page 19.

10. Store the Finished Preset in the Device

If you are working in Live Mode, the preset is already stored in the device. If you are working in

Design Mode

, click the [Store Preset] button on the control bar of the main window. For more

information, refer to the Preset Management section on page 28. To duplicate this preset you need to

be in Design Mode. Simply continue to click the [Store Preset] button, creating duplicates until you have

stored as many presets in the device as you require.

11. Enable External Control

Once you are finished creating and editing presets, if you previously disabled control connections

in order to control the System Processor via the computer, open the Control Pins window and re-

enable them

Establish Security

This is the final step in setting up the device. Before continuing, you should thoroughly read the

Security section on page 85. These instructions are intended only as an overview of the process.

1. Go Live with the System Processor.

You must be in Live Mode to set device security. If you are in Design Mode, click the [Live Mode] button

on the control bar of the main window.

2. Set a Password

Select [Security>Set Password] from the main menu, which opens the Create Password dialog. Type in

a password, press T

AB, and then type it again to confirm. Click [OK].

3. Set the User Access Level

Select [Security>Set Level] from the main menu, which opens the Set Security dialog. Select the

appropriate user access level. Click [OK].