Installation guide

ENGLISH

AUDIO CONNECTIONS

NOTE: The P4800 ships with a blank configuration. Audio will not pass from the inputs to the outputs until it has been configured to do so

through the computer interface.

Wiring Connectors

TR S

XLR

RCA

Phone Plug (Balanced)

Phone Plug (Unbalanced)

Analog Inputs and Outputs

Block Connector Terminal

Level Meters/LEDs

Input Level Meters Output Level Meters

Illuminates at 3 dB below clipping

+4 dBu, –10 dBV selectable through soft-

ware

+4 dBu, –10 dBV selectable through software.

(Does not reflect 20 dB pad.)*

Illuminates at 3 dB below clipping

Illuminates when channel is muted. Illuminates when channel is muted.

Illuminates when pad is engaged through the software.

*NOTE: The output meter reflects the signal level at the output stage of the P4800. The 20 dB pad acts upon the signal after the

output stage, so it does not reflect the 20 dB pad.

20 dB Pad

Each output has a 20 dB pad that can be engaged through the software interface. Use this pad when connecting the P4800 to lower-

level inputs. It cannot be used to prevent clipping at the output stage of the P4800.