User's Manual
Table Of Contents
- Table of Contents
- MV88plusMV88+ Video Kit
- General Description
- Quick Setup
- Quick Setup
- The MV88+ Microphone
- Aiming the Microphone
- The MOTIV App
- Advanced Mic Settings
- Record
- Recording Tips
- Using MV88+ with your Mac and PC
- My Recordings
- Editing Your Audio
- Editing Your Audio
- Sharing MOTIV Recordings
- Sharing MOTIV Recordings
- Troubleshooting
- Firmware
- System Requirements
- Specifications
- Specifications
- MFi Certified
- DSP Modes (Presets)
- Transducer Type
- Polar Pattern
- Stereo Principle
- Frequency Response
- Adjustable Gain Range
- Sensitivity
- Maximum SPL
- Limiter
- Compressor
- Equalizer
- Power Requirements
- Housing
- Net Weight
- Dimensions
- Bit DepthSampling Rate2448 kHz2444.1 kHz1648 kHz1644.1 kHzFrequency Response
- Supported Audio Formats
- Accessories
- Accessories
- Certifications
Shure Incorporated
37/38
1.
2.
•
•
•
•
Accessories
Furnished Accessories
MV88 Foam Windscreen AMV88-WS
MV88 Carrying Case AMV88-CC
1 15 inch USB-C cable AMV-USBC15
1 15 inch Lightning cable AMV-LTG15
Manfrotto Table Top Tripod ManfrottoTabletop
Mobile Device Threaded Clamp DeviceClamp
MV88 Plus Mic Clip with Camera Shoe MV88PlusMicClip
Optional Accessories
Rycote Windjammer for MV88 AMV88-FUR
Certifications
Information to the user
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/NMB-3(B)
Note: Testing is based on the use of supplied and recommended cable types. The use of other than shielded (screened) cable types may degrade EMC per-
formance.
This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance
Authorized European representative: