User's Manual

2.4 GHz Frequency Tables
The following tables list receiver channels, frequencies, and latency for each
group:
FrequenciesGroup/Channel
2424 2425 2442 2443 2462 24641/1
2418 2419 2448 2450 2469 24711/2
2411 2413 2430 2431 2476 24771/3
2405 2406 2436 2437 2455 24571/4
FrequenciesGroup/Channel
2423 2424 2443 2444 2473 24742/1
2404 2405 2426 2427 2456 24572/2
2410 2411 2431 2432 2448 24492/3
2417 2418 2451 2452 2468 24692/4
2437 2438 2462 2463 2477 24782/5
FrequenciesGroup/Channel
2415 2416 24433/1
2422 2423 24393/2
2426 2427 24573/3
2447 2448 24683/4
2409 2451 24523/5
2431 2462 24633/6
2404 2473 24743/7
2435 2477 24783/8
FrequenciesGroup/Channel
2404 2405 2410 2411 2417 2418 2423 2424
2426 2427 2431 2432 2437 2438 2443 2444
2448 2449 2451 2452 2456 2457 2462 2463
2468 2469 2473 2474 2477 2478
4/1
Receiver Operation
Audio Gain Adjustment
Transmitter gain has an adjustment range from -20 dB to +40 dB, in 1 dB
increments.
Tip: Try the 0 dB (unity gain) setting as a starting point, and then make gain
adjustments if necessary.
1. Press and hold the mode button on the receiver until dB appears on the
display.
2. Press the up/down arrows to adjust the gain. For faster adjustments,
press and hold the buttons.
Note: The intensity of the green audio LED corresponds to the audio level.
Rapid flashing indicates audio clipping. Reduce the gain to remove the
overload.
link
mode autoaudio rf channel
group
rf channel
group
auto
link
mode audio
d B - 9
Locking and Unlocking the Controls
The controls of the receiver and transmitter can be locked to prevent acciden-
tal or unauthorized changes to settings.
The following parameters are not affected by locking the controls:
• Lock status is not changed by power cycles
• Tuner functionality and editing remains available
• The receiver power switch does not lock
Locking the Receiver Controls
Simultaneously press and hold the group and channel buttons to lock or un-
lock the receiver.
• LK is displayed if a locked control is pressed
• UN is displayed momentarily to confirm the unlock command
Locking the Transmitter Power Switch
Starting with the transmitter set to off, press and hold the LINK button while
turning on the transmitter. Repeat sequence to unlock.
Note: The transmitter status LED will flash red/green if a locked switch is set
to the off position.
Remote ID
Use the Remote ID feature to identify linked transmitter and receiver pairs.
When Remote ID is active, the receiver LCD will blink and display ID. The
status LED of the corresponding transmitter will alternately flash red and
green for approximately 45 seconds.
To activate Remote ID:
1. Momentarily press the link button on the transmitter or receiver.
2. The display of the linked receiver will blink and show ID and the status
LED on the linked transmitter will flash red/green.
Shure IncorporatedGLXD6 Guitar Pedal Receiver with Integrated Tuner
2017/09/158/17