User's Manual

Using the Tuner
1. Press the footswitch to enter tuner mode.
2. Play each note individually. The display shows the name of the note.
3. Adjust tuning until both indicators illuminate and the needle or strobe in-
dicate that tuning is correct.
Needle Mode
Both tuning indicators and the center green segment will illuminate when the
note is in tune.
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
In Tune
Flat
Sharp
Strobe Mode
Both tuning indicators will illuminate and the strobe segments will remain
stationary when the note is in tune.
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
In Tune
Flat
Sharp
Using a Third-Party Power Supply
To power your GLXD6 wireless receiver pedal, we recommend using the included power supply or a power supply with isolated power outputs.
If using a power supply with isolated power outputs, use a power outlet rated at a minimum of 250 mA.
However, if using other third-party power supplies:
• Check the power consumption for each pedal in a daisy-chain setup. You must know the total power consumption for all of your pedals to avoid overloading
the power supply.
• If no power requirement is listed on the pedal, consult the pedal manufacturer.
Shure IncorporatedGLXD6 Guitar Pedal Receiver with Integrated Tuner
2017/09/1512/17