Tus neeg siv phau ntawv
Table Of Contents
- Table of Contents
- GLXD14+ bGLXD24+
- System Overview
- Quick Start
- Receiver Controls and Connectors
- Receiver Controls and Connectors
- Receiver Screen
- Receiver Screen
- Transmitters
- Transmitters
- Installing Transmitter Batteries
- Installing Transmitter Batteries
- Multiple Receiver Systems
- Manually Linking a Transmitter to a Receiver
- Combo Systems
- Firmware
- Operation
- Accessories
- Specifications
- Tuning Bandwidth
- Working Range
- Transmit Mode
- Audio Frequency Response
- Dynamic Range
- RF Sensitivity
- Total Harmonic Distortion
- RF Output Power
- Operating Temperature Range
- Storage Temperature Range
- Polarity
- Battery Life
- Guitar Tuner
- Channel Count
- GLXD1
- Dimensions
- Weight
- Power Requirements
- Housing
- Input Impedance
- RF Output Power
- Transmitter Input
- Connector
- Configuration
- Maximum Input Level
- Antenna Type
- Pin Assignments
- Pin Assignments
- Dimensions
- Dimensions
- Weight
- Housing
- Power Requirements
- Spurious Rejection
- Gain Adjustment Range
- Phantom Power Protection
- Tuning Bandwidth
- Working Range
- Transmit Mode
- Audio Frequency Response
- Dynamic Range
- RF Sensitivity
- Total Harmonic Distortion
- RF Output Power
- Operating Temperature Range
- Storage Temperature Range
- Polarity
- Battery Life
- Channel Count
- Configuration
- Impedance
- Maximum Audio Output Level
- Pin Assignments
- Impedance
- Antenna Type
- Maximum Input Level
- Information to the user
- Certifications
Shure Incorporated
8/20
1.
2.
3.
1.
2.
3.
Installing Transmitter Batteries
Bodypack Transmitter
Move the locking lever to the open position and slide the battery door open.
Place the battery into the transmitter.
Close the battery door and slide the latch to lock.
Handheld Transmitter
Unscrew and remove the battery cover.
Place the battery into the transmitter.
Replace and tighten the battery cover.
Multiple Receiver Systems
For ease of set up, frequencies are divided into groups to best match the channel requirements for your system.
Select the group by determining the total number of receivers in your system (channel count). All receivers in the system must
be set to the same group.
DRAFT