User's Manual
Table Of Contents
- Table of Contents
- GLXD4Wireless Receivers
- IMPORTANT SAFETY INSTRUCTIONS
- System Overview
- System Overview
- Accessories
- Quick Start
- GLXD4 Receiver Controls and Connectors
- GLXD4 Receiver Controls and Connectors
- Receiver Screen
- Transmitters
- Batteries and Charging
- Multiple Receiver Systems
- Multiple Receiver Systems
- Manually Linking a Transmitter to a Receiver
- Manually Linking a Transmitter to a Receiver
- Combo Systems
- 2.4 GHz Spectrum Overview
- Tips and Methods to Improve Wireless System Performance
- 2.4 GHz Frequency Tables
- 2.4 GHz Frequency Tables
- Firmware
- Operation
- Troubleshooting
- Resetting Components
- Specifications
- Tuning Bandwidth
- Working Range
- Transmit Mode
- Audio Frequency Response
- Dynamic Range
- RF Sensitivity
- Total Harmonic Distortion
- RF Output Power
- Operating Temperature Range
- Storage Temperature Range
- Polarity
- Battery Life
- Guitar Tuner
- Channel Count
- GLXD1
- Dimensions
- Weight
- Power Requirements
- Housing
- Input Impedance
- RF Output Power
- Transmitter Input
- Connector
- Configuration
- Maximum Input Level
- Antenna Type
- Pin Assignments
- Pin Assignments
- Dimensions
- Dimensions40 x 183 x 117 mm (1.6 x 7.2 x 4.6 in.), H x W x D Weight286 g (10.1 oz.) without batteries HousingMolded Plastic Power Requirements14 to 18 V DC (Tip positive with respect to ring), 550 mA Spurious Rejection>35 dB, typical Gain Adjustment Range-20 to 40 dB in 1 dB steps Phantom Power ProtectionYes Tuning Bandwidth2400–2483.5 MHz Working RangeIndoorUp to 30 m (100 ft) typical , Up to 60 m (200 ft) maximumOutdoorUp to 20 m (65 ft) typical , Up to 50 m (165 ft) maximumNote: Actual range depends on RF signal absorption, reflection and interference. Transmit ModeFrequency Hopping Audio Frequency Response20 Hz – 20 kHz Note: Dependent on microphone type Dynamic Range120 dB, A-weighted RF Sensitivity-88 dBm, typical Total Harmonic Distortion0.2%, typical RF Output Power10 mW E.I.R.P. max Operating Temperature Range-18°C (0°F) to 57°C (135°F) Note: Battery characteristics may limit this range. Storage Temperature Range-29°C (-20°F) to 74°C (165°F) PolarityPositive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive voltage on pin 2 (with respect to pin 3 of low-impedance output) and the tip of the high impedance 1/4-inch output. Battery LifeUp to 16 hours Channel Count4 typical , Up to 8 maximum
- Dimensions
- Weight
- Housing
- Power Requirements
- Spurious Rejection
- Gain Adjustment Range
- Phantom Power Protection
- Tuning Bandwidth
- Working Range
- Transmit Mode
- Audio Frequency Response
- Dynamic Range
- RF Sensitivity
- Total Harmonic Distortion
- RF Output Power
- Operating Temperature Range
- Storage Temperature Range
- Polarity
- Battery Life
- Channel Count
- Configuration
- Impedance
- Maximum Audio Output Level
- Pin Assignments
- Impedance
- Antenna Type
- Maximum Input Level
- Certifications
- Information to the user
Shure Incorporated
32/34
1.
2.
1.
2.
•
•
Pin Assignments
XLR Output 1=ground, 2=hot, 3=cold
6.35 mm (1/4") connector Tip=audio, Ring=no audio, Sleeve=ground
Receiver Antenna Input
Impedance
50 Ω
Antenna Type
½ Wave Sleeve Dipole, non-removable
Maximum Input Level
−20 dBm
Certifications
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
This wireless system operates in the globally available ISM band 2400 MHz to 2483.5 MHz. The operation does not require a
user license.
Certified by ISED in Canada under RSS-210 and RSS-GEN.
IC: 616A-GLXD1, 616A-GLXD2, 616A-GLXD4
Certified under FCC Part 15.
FCC ID: DD4GLXD1, DD4GLXD2, DD4GLXD4
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/NMB-3(B)
This device contains licenceexempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Develop
ment Canada’s licenceexempt RSS(s). Operation is subject to the following two conditions:
This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
L’appareil ne doit pas produire de brouillage;
L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Meets essential requirements of the following European Directives:
WEEE Directive 2012/19/EU, as amended by 2008/34/EC
RoHS Directive EU 2015/863
Note: Please follow your regional recycling scheme for batteries and electronic waste