Specifications

CERTIFICATIONS

DFR11EQ (Version 5)

UL Listed and cUL Listed to UL 6500 and CSA E65. Approved under the verification provision of FCC part 15 as

a Class B Digital Device.

DFR11EQE (Version 5)

Eligible to bear CE marking. Conforms to European Union Low Voltage Directive 73/23/EEC; VDE

GS–Certified to EN 60065. Conforms to European Union EMC Directive 89/336/EEC; Emissions per EN

50081–1 (1992) and Immunity per EN 50082–1 (1992).

NOTE:

*EMC conformance testing is based on the use of supplied and recommended cable types. The use of other cable

types may degrade EMC performance.

*Under extremely abnormal conditions of electrical fast transients on the power line, communication may be

interrupted between the DFR11EQ and the controlling PC. The unit will not be damaged; normal operation will resume

after the CONNECT button or command is used to restore the connection

*This Class B digital apparatus complies with Canadian ICES–003.

FURNISHED ACCESSORIES

Power Cable (DFR11EQ5/DFR11EQJ)* 95A8389. . . . . . . . . . . . . . . . . . . . . . . . . . .

Power Cable (DFR11EQ5E)* 95A8247. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Power Cable Clamp* 95A8712. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

5-pin DIN Shure Link Cable 95A8676. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Single Mount Rack Bracket 53A8450. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Dual Mount Rack Bracket 53B8442. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Straddle Bars 53B8443. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

DFR11EQ Version 5 Software/User’s Guide CD–ROM 95A8830A. . . . . . . . . . . . .

*NOTE: The power cord and power cable clamp is supplied assembled. If a replacement power cord is needed, a power

cord clamp is also required. If not assembled, the power cord clamp should be clamped as close to the female end of the

power cord as possible.

INFORMATION TO USER

Changes or modifications not expressly approved by Shure Brothers Inc. could void your authority to operate this

equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following measures:

S Reorient or relocate the receiving antenna.Reorient or relocate the receiving antenna.

S Increase the separation between the equipment and receiver.Increase the separation between the equipment

and receiver.

S Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

S Consult the dealer or an experienced radio/TV technician for help.Consult the dealer or an experienced

radio/TV technician for help.

Table of Contents