Specifications

EQUALIZER

The Equalizer module of the DFR11EQ Version 5 software can be set to work as a parametric

equalizer or as a graphic equalizer, according to your needs. There is an Equalizer Options window

(under Options on the Main Menu Bar) for you to set the equalizer type.

Graphic Equalizer

In Graphic Equalizer mode, the software allows the DFR11EQ to act as a constant-Q, 30-band,

-octave graphic equalizer with up to 6 dB of boost and 12 dB of cut per band. Additional high and

low frequency cut filters with a 12 dB/octave rolloff are included for setting the bandwidth limit of the

sound system.

NOTE: See the

Output Controls

section for details on the functions of the OUTPUT

control located on the right side of the Equalizer Control window.

Setting up the Graphic Equalizer

1. Click on

Options

in the main menu bar.

2. Click on

Equalizer...

3. In the

Equalizer Options

window, click on the Graphic Equalizer button.

4. Click on the OK button.

This operation may also be performed by using the EQ Type button on the Equalizer Control

Window.

NOTE: In the Equalizer Options window, there are also three buttons for Version 3

Software, Version 4 Software and Version 5 Software. In the off–line mode, all three of

these are selectable, to allow the user to edit scenes using the appropriate software. In

the on-line mode, the appropriate software is identified. If Version 3 software is detected,

the user may upgrade to Version 4 software by selecting the Version 4 button.

Table of Contents