User's Manual

3
Transmitter LED Indicators
LED Indicator Status
Green Ready
Rapidly Flashing Red Controls locked
Solid Red Battery power low (less than 1 hour remaining*)
Flashing Red and shuts off Batteries dead (change batteries to power on transmitter)
*For alkaline batteries only. For rechargeable batteries, solid red means the batteries are dead.
Single System Set Up
group
(A-Y)
Setting Transmitter Group and Channel
Transmitter group and channel must be manually set to match the receiver.
Group (letter)
1. Press and release the group button on the transmitter
to activate the display. Press the group button again
and the display flashes.
2. While the display is flashing, press the group button
again to advance to the desired group setting.
Channel (number)
If channel needs to be changed, follow the same pro-
cedure using the channel button instead of the group
button.
Note:
• When the group and channel correctly match the
receiver, the ready LED on receiver illuminates.
• After manual setup, the transmitter alternately displays
the group and channel setting for about two seconds.
1. Press and release the group button on the receiver.
The receiver scans for the clearest group and
channel.
Note: If you want to stop the scan, push the group
button again.
2. Turn on transmitter and change the group and chan-
nel to match the receiver (See Setting Transmitter
Group and Channel).
Once the system is set up, perform an audio check and
adjust the gain if necessary.
Before you begin, turn off all transmitters and turn on any equipment (other microphones or personal monitoring systems)
that could cause interference during the performance.
channel
group
channel
group
group
channel
x 2
x 2
English