User's Manual

Expected life for AA batteries is up to 14 hours (total

battery life varies depending upon battery type and

manufacturer).

When the LED indicator turns red, it signifies "low battery"

with approximately 60 minutes of remaining battery life.

For alkaline batteries only. For rechargeable batteries,

solid red means the batteries are dead.

To remove batteries from the handheld transmitter, push

them out through the opening in the microphone battery

compartment.

WARNING: Danger of explosion if battery

incorrectly replaced. Operate only with Shure

compatible batteries.

WARNING: Battery packs shall not be exposed

to excessive heat such as sunshine, fire, or

the like.

Wearing the Bodypack

Transmitter

Clip the transmitter to a belt or slide a guitar strap through

the transmitter clip as shown.

For best results, the belt should be pressed against the

base of the clip.

Power Off

Hold down the power button to power off the BLX2 or

BLX4/88. To power off the BLX1, slide the power toggle

switch to OFF.

Removing and Installing

Identification Caps

The BLX2 is equipped with a black identification cap from

the factory (dual vocal systems comes with a black and

gray cap).

To remove: Remove battery cover. Squeeze sides and

pull off cap.

To install: Make sure the tab matches the slot on the bot-

tom of the handheld and click into place. Replace battery

cover.

An optional Identification Cap Kit containing 9 colored

caps is available (see Optional Accessories).

Batteries