Owner's Manual

Certifications
This product meets the Essential Requirements of all rel-
evant European directives and is eligible for CE marking.
The CE Declaration of Conformity can be obtained from
Shure Incorporated or any of its European representatives.
For contact information please visit www.shure.com
The CE Declaration of Conformity can be obtained from:
www.shure.com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: [phone]
Fax: [phone]
11 4
Email: [e-mail]
BLX1,BLX2
Certified under FCC Part 7 4.
Certified by IC
in Canada under RSS-123 and RSS-1 02.
FCCID:DD4BLX1A,DD4BLX1B,DD4BLX1C,
DD4BLX1D;DD4BLX2A,DD4BLX2B,DD4BLX2C,
DD4BLX2D,DD4BLX1W,DD4BLX1S,DD4BLX2W,
DD4BLX2S. IC: 616A-BLX1 A, 616A-BLX1 B,
616A-BLX1C,616A-BLX1D;616A-BLX2A,616A-BLX2B,
616A-BLX2C, 616A-BLX2D
Certified by IC
in Canada under RSS-1 02 and RSS-21 0.
IC: 616A-BLX1 W, 616A-BLX1 S, 616A-BLX2W,
616A-BLX2S
BLX4,BLX88
Approved under the Declaration of Conformity (DoC) pro-
vision of FCC Part 15.
Australia Warning for Wireless
This device operates under an ACMA class licence and
must comply with all the conditions of that licence includ-
ing operating frequencies. Before
31 December 2014,
this device will comply if it is operated
in the 520-820 MHz
frequency band.
WARNING: After 31 December 2014, in
order to comply, this device must not be operated in the
694-820 M Hz band.
Important Product Information
LICENSING INFORMATION
Licensing: A ministerial license to operate this equipment
may be required
in certain areas. Consult your national
authority for possible requirements. Changes or modifica-
tions not expressly approved by Shure Incorporated could
void your authority to operate the equipment. Licensing
of Shure wireless microphone equipment is the user's
responsibility, and licensability depends on the user's clas-
sification and application, and on the selected frequency.
Shure strongly urges the user to contact the appropriate
telecommunications authority concerning proper licensing,
and before choosing and ordering frequencies.
Information to the user
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
in a
residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed
and used
in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur
in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
the receiver.
Connect the equipment to an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation of this device is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interfer-
ence, including interference that may cause undesired
operation of the device.
Le present appareil est conforme aux CNR d'lndustrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisee aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioelectrique subi, meme
si le brouillage est susceptible
d'en compromettre le fonctionnement.
This device operates on a no-protection no-interference
basis. Should the user seek to obtain protection from other
radio services operating
in the same TV bands, a radio
licence is required. Please consult Industry Canada's
document CPC-2-1-28, Optional Licensing for Low-Power
Radio Apparatus
in the TV Bands, for details.
Industry Canada ICES-003 Compliance Label: CAN
ICES-3 (B)/NMB-3(B)
Note: EMC conformance testing is based on the use of
supplied and recommended cable types. The use of other
cable types may degrade EMC performance. '
Changes or modifications not expressly approved by
the manufacturer could void the user's authority to
operate the equipment.
Please follow your regional recycling scheme for batteries,
packaging, and electronic waste.
9