SH U ® LEGEND ARY PERFOR MANCE™ BLX® Wireles s Microp hone System System e de microp hone sans fil BLX® Sistem a de micr6fo nos inalam bricos BLX® Sistem a de Microfo ne Sem Fio BLX® ©2015 Shure Incorporated 27A29459 (Rev.
IMPORTANT SAFETY INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. READ these instructions. KEEP these instructions. HEED all warnings. FOLLOW all instructions. DO NOT use this apparatus near water. CLEAN ONLY with dry cloth. DO NOT block any ventilation openings. Allow sufficient distances for adequate ventilation and install1n accordance with the manufacturer's instructions.
& Caution For proper operation, set each transmitter to a different channel on the BLX88 receiver. Consult your BLX Channel guide to select compatible channel sets. & Attention Pour un fonctionnement correct, regler chaque cote du recepteur double BLX88 sur un canal different. 6 Consulter le guide des canaux BLX pour selectionner des jeux de canaux compatibles. &, Cuidado Para operac;:ao correta, ajuste cada lado do Receptor duplo BLX88 em um canal diferente.
Quick Start Guide G) a) Connect receiver to power source. Brancher le recepteur d'alimentation. a une source Den Empfanger an die Stromversorgung anschlieBen. Conecte el receptor a Ia fuente de alimentaci6n. b) Connect receiver to mixer or amplifier. Hold power button to turn on. Brancher le recepteur a un melangeur ou un amplificateur. Appuyer sur le bouton d'alimentation pour allumer le recepteur. Den Empfanger an das Mischpult oder den Verstarker anschlieBen.
a) Install batteries and turn on transmitter. lnstallate le pile ed accendete il trasmettitore. l!~XI. ~xl~ q~ :§' ~71~ ~~AI.2.. Installer les piles et allumer l'emetteur. lnstale as pilhas e ligue o transmissor. ~~~sm1HT1f~t-tm E@.jjj{o Die Batterien/Akkus einlegen und den Sender einschalten. Bcrasbre 6arapeHKH H BK11104HTe nepe.QaT4HK. Pasang baterai dan hidupkan pemancar. i!f~t~l:t~~m~Ati. ;t/f;: (..,*go lnstale las baterfas y encienda el transmisor.
If setting up additional systems, leave the first transmitter and receiver on . For each additional receiver, manually set the group to match the first receiver. Note: The receiver will automatically perform a channel scan to find an available frequency after the group has been selected . Set the transmitter frequency to match the receiver. Si l'on configure d'autres systemes, laisser les premiers emetteur et recepteur allumes.
Features Front Panel BLX4 SHU~ ready 2 BLX88 SHUiiC,E ready ready 2 2 CD audio LED Indicates strength of incoming audio signal: green for normal and red for overload. ®ready LED Green light indicates system is ready for use and receiving transmitter signal. @ LED Display Displays group and channel setting. @ group and channel Buttons Scan: Push and release group button to scan for an open group and channel. Manual: Push and hold group button to select a group.
Back Panel BLX4 BLX88
Transmitter LED Indicators LED Indicator Status Green Ready Rapidly Flashing Red Controls locked Solid Red Battery power low (less than 1 hour remaining*) Flashing Red and shuts off Batteries dead (change batteries to power on transmitter) *For alkaline batteries only. For rechargeable batteries, solid red means the batteries are dead.
Multiple System Setup Up to 12 systems can operate simultaneously (band and RF environment dependent). Important: Set up each system one-at-a-time. Once a receiver and transmitter are tuned to the same group and channel, leave the transmitter powered on. Otherwise, scans from the other receivers will not detect that channel as occupied. For the BLX88, be sure to setup both transmitters before progressing to the next receiver.
Tips to Improve Wireless System Performance If you encounter interference or dropouts, try the following suggestions: Choose a different receiver channel Reposition the receiver so there is nothing obstructing a line of sight to the transmitter (including the audience) • Avoid placing transmitter and receiver where metal or other dense materials may be present Move the receiver to the top of the equipment rack · Remove nearby sources of wireless interference, such as cell phones, two-way radios, computers,
Batteries Expected life for AA batteries is up to 14 hours (total battery life varies depending upon battery type and manufacturer). 0 0 When the LED indicator turns red, it signifies "low battery" with approximately 60 minutes of remaining battery life. For alkaline batteries only. For rechargeable batteries, solid red means the batteries are dead. To remove batteries from the handheld transmitter, push them out through the opening in the microphone battery compartment. ,. \ I I \ \ WARNING: Dang
Troubleshooting Issue Indicator Status Solution No sound or faint sound Receiver ready LED on • Verify all sound system connections or adjust gain as needed (see Adjusting Gain) • Verify that the receiver is connected to mixer/ amplifier Receiver ready LED off • Turn on transmitter • Make sure the batteries are installed correctly • Perform transmitter setup (see Single System Setup) • Insert fresh batteries Receiver LED screen off • Make sure DC adapter is securely plugged into electrical outlet.
BLX2 System Audio Input Level Working Range gain 91 m (300 ft) Line of Sight Note: Actual range depends on RF signal absorption, reflection and interference. Audio Frequency Response OdB -20 dBV maximum -10d8 -1 0 dBV maximum Gain Adjustment Range 10 dB 50 to 15,000 Hz Note: Dependent on microphone type RF Transmitter Output Total Harmonic Distortion 10 mW, typical Ref. ±33 kHz deviation with 1 kHz tone varies by region 0.5%, typical Dimensions Dynamic Range 224 mm X 53 mm L x Dia.
Certifications This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking. Important Product Information The CE Declaration of Conformity can be obtained from Shure Incorporated or any of its European representatives. For contact information please visit www.shure.com LICENSING INFORMATION The CE Declaration of Conformity can be obtained from: www.shure.
Frequency Range and Transmitter Output Level Band Range Output Power H8 518 to 542 MHz 10mW H8E 518 to 542 MHz 10 mW H9 512 to 542 MHz 10mW H10 542 to 572 MHz 10mW J10 584 to 608 M Hz 10mW K3E 606 to 630 MHz 10mW K12 614 to 638 MHz 10mW K14 614 to 638 MHz 10mW M15 662 to 686 M Hz 10mW M17 662 to 686 MHz 10mW 025 742 to 766 MHz 10mW R12 794 to 806 MHz 10mW 88 823 to 832 MHz 10 mW T11 863 to 865 MHz 10mW Note: Frequency bands might not be available for sale or auth
LEGENDARY PERFORMANCE T" United States, Canada, Latin America, Caribbean: Shure Incorporated 5800 West Touhy Avenue Niles, IL 60714-4608 USA Phone: + 1 847-600-2000 Fax: +1 847-600-1212 (USA) Fax: + 1 847-600-6446 Email: info@shure.com www.shure.com Europe, Middle East, Africa: Shure Europe GmbH Jakob-Dieffenbacher-Str. 12, 75031 Eppingen, Germany Phone: +49-7262-92490 Fax: +49-7262-9249114 Email: info@shure.de www.shure.
sau;;u:· LEGEND A RY CVL PERF O RMAN C E • ~ ~~ - ~ -- • ' '-" -'"-- ""- ~· - ,_ -- "' CVL Lavalier Microphone ··--· ·-·-·-·--······~· The Shure CVL is an electret condenser lavalier microphone ideal lor use in speech and other applications requiring minimal visibility. Using the Microphone 1. tnstallthesuppliedwindscreenonthemicrophone 2. Attach the microphone to a shirt collar or necktie using the supplied clip. For best results, the microphone should be 15-25 em (6-10 in.
Spepifications Caract$ristiques. Equivalent Output Noise PI Type lypic<>l, A-Weighted Electret Condenser Type Bruit de sortie equivalent t•l Power Requirements +5 V DC (nominal), 10 V maximum (DC bias) Polar Pattern Unidirectionai(Cardioid ) Positivepressureondiaph rag mproducespositivevoltageonpin3w•th respect to pint 6000 Audio Output Level -43.5dBV/Pa Signal-To-Noise Raliot•t @I kHz 72dB Cable 1.3m (50in.) Connector Alimentation 50Hzil20.000Hz Polarite Unepressionacoustiqueposit;..
LIMITED WARR·A NTY Shure lncorpo·rated ("Shure") hereby warrants to the original consumer purchaser only that, except as otherwise specified below, this product will be free in normal' use of any defects in materials and workmanship for a period of two (2) years from the consumer's original date of purchase directly from Shure or from a Shure-authorized reseller.
® SHU Service Centers United States, Canada, Lati~ America, Carribbean Shure Incorporated Attn: Service Department 5800 W. Touhy Avenue Niles, IL 60714-4608 U.S.A. Europe, Middle East, and Africa Shure Europe GmbH Attn: Service Jakob-Dieffenbacher-Str. 12 74078 Eppingen, Germany Asia Shure Asia Limited 22/F, 625 King's Road North Point, Island East Hong Kong Attention: Service Department Phone: (852) 2893-4290 Fax: (852) 2893-4055 Email: info@shure.com.
® LIMITED WARRANTY © 2012, Shure Incorporated 27E3175 (Rev. 1) f!J ~ I Printed in China 1.16.GSI31.00501.
