User guide

5
Additional Input Capabilities
In addition to receiving audio input from mixing console inserts, the AuxPander can also accept standard inputs from
line-level devices, as described below.
Inserts
Plug line-level sources into the INSERT jack and set the INSERT ASSIGN switch to REMOTE. Adjust level and balance
to feed the signal to the stereo outputs.
INSERT ASSIGN
“Half-Normal” Connection (IN/OUT Jack)
You can connect unbalanced line-level outputs to the IN/OUT jacks. Insert the
1
/
4
” phone plug halfway into the IN/OUT
jack until the first “click.” The INSERT jacks remain available for inserting processing locally.
1
/
4
” mono phone plug
from line-level output
AuxPander IN/OUT jack
First “click”
Direct Inputs
The DIRECT INPUT jacks on the back of the AuxPander feed signal directly to the outputs, bypassing the mix bus.
(See Callout H in the next section.)
Daisy Chain Connection for Mono Monitoring
Use this method to add a signal to four mono outputs.
1. Use the BALANCE knobs to pan input from the IN/OUT jacks all the way to the left.
2. Plug a mono input into the STEREO A DIRECT INPUT L/MONO jack.
3. Use a 1/4” phone patch cord to connect all the right outputs (OUTPUT–R) outputs to the mono direct inputs
(DIRECT INPUT–L/MONO) of the next stereo bus.
4. Continue the daisy chain as necessary by connecting the right (R) STEREO D OUTPUT jack to a DIRECT
INPUT jack of another AuxPander.
1
23 4
AuxPander Outputs
Line
Input
AuxPander
Balance Controls