User's Manual
Table Of Contents
- Table of Contents
- AD4DDual Channel Receiver
- IMPORTANT SAFETY INSTRUCTIONS
- Australia Warning for Wireless
- AD4D Axient Digital Two-Channel Wireless Receiver
- Included Components
- Mounting Instructions
- Hardware
- Menus and Configuration
- Radio Frequency (RF) Settings
- Setting the RF Tuning Band
- IR Sync
- Setting the Frequency Manually
- Channel Scan and Group Scan
- Requesting a New Frequency from a Spectrum Manager
- Transmission Modes
- Assigning Transmitters to Transmitter Slots
- Interference Management
- Channel Quality Meter
- Frequency Diversity
- Antenna Bias
- RF Cascade Ports
- Firmware
- Audio Settings
- Networking
- Operation
- Troubleshooting
- Specifications
- System Specifications
- RF Carrier Frequency Range
- Working Range
- RF Tuning Step Size
- Channel-to-Channel Spacing
- Channel-to-Channel Spacing
- Image Rejection
- RF Sensitivity
- Latency Analog Output
- Audio Frequency Response
- Signal-to-Noise Ratio(Dynamic Range)
- Total Harmonic Distortion
- System Audio Polarity
- Operating Temperature Range
- Storage Temperature Range
- Audio Output
- Gain Adjustment Range
- Configuration
- Impedance
- Full Scale Output (200K Ω load)
- Mic/Line Switch
- Phantom Power Protection
- Dimensions
- Weight
- Housing
- Power Requirements
- Thermal Power Dissipation
- DC Power Requirements
- Network Interface
- Network Addressing Capability
- Maximum Cable Length
- Cascade Output
- Connector Type
- Configuration
- Impedance
- Insertion Loss
- RF Input
- Spurious Rejection
- Connector Type
- Impedance
- Bias Voltage
- RF Carrier Frequency Range model dependent
- Tables and Diagrams
- Receiver Frequency Bands
- Certifications
- Certifications
- Contact Customer Support
Shure Incorporated
9/41
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
◦
Receiver Back Panel
① AC Power Input
IEC locking connector, 100 - 240 V AC.
② AC Power Protection Fuse
Protects the AC power cascade from overloads.
③ AC Power Cascade (locking)
Use IEC extension cables to loop power through multiple devices.
④ Ethernet Ports
Four Ethernet ports carry the following signals:
ctrl 1: Network control
ctrl 2: Network control
Dante Primary: Dante digital audio
Dante Secondary: Dante digital audio
Network Status (green) LEDs:
Off: no network link
On: network link active
Flashing: network link active, rate corresponds to traffic volume
Network Speed (amber) LEDs:
Off = 10/100 Mbps
On = 1 Gbps
⑤ Word Clock Input and Thru Ports
Input: Connect to an external word clock to resolve the AES3 digital output
Thru: Passes word clock signal to additional components
⑥ Word Clock Termination Switch
Set to Thru when passing signal to additional components
Set to Term 75Ω when Thru connection is not used
⑦ AES3 Digital Audio Output
Connector for AES3 Digital Audio.