User's Manual
Table Of Contents
- Table of Contents
- AD4DDual Channel Receiver
- IMPORTANT SAFETY INSTRUCTIONS
- Australia Warning for Wireless
- AD4D Axient Digital Two-Channel Wireless Receiver
- Included Components
- Mounting Instructions
- Hardware
- Menus and Configuration
- Radio Frequency (RF) Settings
- Setting the RF Tuning Band
- IR Sync
- Setting the Frequency Manually
- Channel Scan and Group Scan
- Requesting a New Frequency from a Spectrum Manager
- Transmission Modes
- Assigning Transmitters to Transmitter Slots
- Interference Management
- Channel Quality Meter
- Frequency Diversity
- Antenna Bias
- RF Cascade Ports
- Firmware
- Audio Settings
- Networking
- Operation
- Troubleshooting
- Specifications
- System Specifications
- RF Carrier Frequency Range
- Working Range
- RF Tuning Step Size
- Channel-to-Channel Spacing
- Channel-to-Channel Spacing
- Image Rejection
- RF Sensitivity
- Latency Analog Output
- Audio Frequency Response
- Signal-to-Noise Ratio(Dynamic Range)
- Total Harmonic Distortion
- System Audio Polarity
- Operating Temperature Range
- Storage Temperature Range
- Audio Output
- Gain Adjustment Range
- Configuration
- Impedance
- Full Scale Output (200K Ω load)
- Mic/Line Switch
- Phantom Power Protection
- Dimensions
- Weight
- Housing
- Power Requirements
- Thermal Power Dissipation
- DC Power Requirements
- Network Interface
- Network Addressing Capability
- Maximum Cable Length
- Cascade Output
- Connector Type
- Configuration
- Impedance
- Insertion Loss
- RF Input
- Spurious Rejection
- Connector Type
- Impedance
- Bias Voltage
- RF Carrier Frequency Range model dependent
- Tables and Diagrams
- Receiver Frequency Bands
- Certifications
- Certifications
- Contact Customer Support
Shure Incorporated
28/41
◦
◦
1.
2.
3.
4.
Configuration options:
LIMITER THRESHOLD: Adjusts the trigger point for the headphone limiter to protect against unexpected increases in sig
nal level
FDS PRE/POST SELECTION: Selects a audio monitoring point in the signal path before or after Frequency Diversity pro
cessing for the headphone. This setting is useful for isolating sources of noise or interference.
System Gain
The System Gain feature allows you to view and calculate all gain stages in the signal chain, including input pads, offsets, and
receiver gain. Audio output levels are updated in real time as gain adjustments are made.
From a selected Channel menu: Audio > System Gain
The display shows the pads and the offsets for transmitters and the receiver gain setting.
Use the control wheel to adjust the receiver gain in real time while monitoring the net output levels at the ¼" (6.3 mm)
output and the XLR output.
Press EXIT when finished.
Networking
Networking Receivers
The receiver features a 4-port network interface. Dante technology provides an integrated solution to distribute digital audio.
Dante uses standard IP over Ethernet and safely coexists on the same network as IT and control data. Selectable networking
modes route port signals for flexible network set up.
Network Control Software
Receivers can be controlled by Shure Control (Wireless Workbench) for remote management and monitoring. The Dante Con
troller manages digital audio routing. Signals for AMX and Crestron controllers are carried on the same network as Shure Con
trol.
Shure Control