User's Manual
Table Of Contents
- Table of Contents
- AD3 Plug-On Transmitter
- WARNING
- AD3 Axient Digital Plug-On Transmitter
- Included Components
- Optional Accessories
- AD3 Transmitter Overview
- Setup
- Setting the AA Battery Type
- Transmitter Controls
- Menu Overview
- Home Screen Display
- Locking the Interface
- IR Sync
- Setting the Frequency Manually
- Updating Firmware
- RF Mute
- Safe Start
- Input Overload
- Input Overload
- Tone Generator
- Matching Audio Levels with Offset
- Menu Item Descriptions
- Specifications
- Mic Offset Range
- Battery Type
- Battery Runtime
- Dimensions
- Weight
- Housing
- Operating Temperature Range
- Storage Temperature Range
- Audio Input
- Connector
- Configuration
- Impedance
- Maximum Input Level
- Preamplifier Equivalent Input Noise (EIN)
- Phantom Power
- High Pass Filter
- RF Output
- Antenna Type
- Impedance
- Occupied Bandwidth
- Channel-to-Channel Spacing
- Modulation Type
- Power
- Specific Absorption Rate (SAR)
- Frequency Bands and Transmitter RF Power
- LICENSING INFORMATION
- Certifications
- Contact Customer Support
Shure Incorporated
11/23
1.
◦
◦
◦
◦
2.
1.
2.
3.
4.
5.
Battery runtime in hours and minutes or bar display
Key: Displayed when encryption is enabled
Lock: Displayed when controls are locked. Icon flashes if you
attempt to access a locked control (power or menu).
STD: Standard Transmission Mode
HD: High Density Transmission Mode
Locking the Interface
Lock transmitter interface controls to prevent accidental or unauthorized changes to parameters. The lock icon appears on the
home screen when a lock is enabled.
From the Utilities menu, navigate to Locks and select one of the following lock options:
None: The controls are unlocked
Power: The power switch is locked
Menu: The menu parameters are locked
All: The power switch and menu parameters are locked
Press O to save.
Tip: To quickly unlock the transmitter menu, press O and select None.
IR Sync
Use IR Sync to form an audio channel between the transmitter and receiver.
Note: The receiver band must match the band of the transmitter.
Select a receiver channel.
Tune the channel to an available frequency using group scan or manually turn to an open frequency.
Power on the transmitter.
Press the SYNC button on the receiver.
Align the IR windows between the transmitter and the receiver so that the IR LED illuminates red. When complete,
Sync Success! appears. The transmitter and receiver are now tuned to the same frequency.