0
Table of Contents: FCC Pa r t …………………………………………………………………. ……………………. 2 Know your camera……………………………………………………………………………3 Start to use……………………………………………………………………………………...5 Install Battery……………………………………………………..….…………………….5 Use SD Card…………………………………………………….………………..………..5 Selecting Lens Mode… ……………………………………………..……………………..6 Turning the camera ON and OFF… …………………………………………………….7 Selecting the MODE of the camera… ……………………………………………………7 Setting Date and Time ………………………………………………………………....
HDV141 FCC part 15.21 Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC part 15.105 Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help. - This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Right/ LED switch Left/ Self timer 8 Mode key 9 Battery cover 10 Speaker 11 Wrist strap loop 12 Wrist strap hole 13 Zoom in key 14 Zoom out key 15 USB/TV out port 16 LED light 17 Self timer indicator 18 Tripod socket 19 SD card slot 20 LCD Screen 20 4
Start to use NOTE: Please insert three fresh AAA batteries and SD/SDHC memory card to operate the camera 1. Installing Batteries 1. Press the top and slide down the Battery Cover. 2. Insert three fresh AAA alkaline batteries; align polarity of terminals correctly. Keep the black ribbon placed under installed batteries; pulling that ribbon later will help remove exhausted batteries. 3. Slide up the Battery Cover to close the battery compartment. 2.
option. Press Right Direction key and then press Up or Down Direction key to select ‘Yes’ option. The memory card will be formatted automatically. Please note that all DATA stored on SD card will be deleted during formatting. 3. Selecting Lens Mode or Macro Slide the Lens Selector to Normal distance between the main subject and the camera. 1. Use Normal setting position depending on the for shooting subjects located 5 feet or more away from the camera 2.
camera 4. Turning the camera ON and OFF 1. Power ON: press the Power key for a second or two to turn the camera ON. 2. Power OFF: when the camera is active press the Power key to turn the power OFF. Auto Power OFF: the camera will turn OFF automatically when has been unused for 1 minute. The Auto Power OFF delay time may be set at 1, 3 or 5 minutes. Go to Setup Mode / Power Save and make adjustment if necessary (see also Section 11 Setup the camera). 3.
6. Setting Date and Time: This option will help you identify “when” your images have been taken. This information will be added to “Properties” of each image and you can retrieve it using computer when camera is connected, or after images are downloaded into computer. Setting: Press the OK button then press Right Direction key to enter Setup Menu.
Busy light - the light will turn on when the camera is “busy” recording video, capturing photo, processing data, or being connected to computer. LED light – this supporting light may be used when recording video/ pictures in dark environment. Please note that this lamp is effective for short distances only. Self Timer light – indicates that the camera Self Timer has been activated. 8.
2. 3. 4. 5. Press / hold the Power key and turn the camera ON Press the Shutter key to start recording video To stop recording, press the Shutter key again. Note that camera will auto-stop recording when the SD memory card is full. You may press Zoom IN / OUT buttons during recording to select desired zoom range. • The LCD screen acts as a viewfinder to help you more accurately point at and center the main subject or person while recording. Setting the resolution for recorded Video 1. 2. 3. 4.
5. Press OK button to confirm your selection then press OK button to exit the menu. 9. Camera mode: Preview mode Image resolution mode Exposure Value Self timer mode icon Image counter Camera Mode icon Zoom ratio range SD card icon; card inserted 10 Self timer counter; photo Will be taken after 10 sec Battery icon LED light icon Shooting Photos 1. Open the LCD screen and press / hold the Power key to turn camera ON 2. Press the Mode key once to select the Camera mode 3.
Setting the resolution for taken photo 1. 2. 3. 4. 5. Press OK button to open the menu. Press Up or Down Direction key to select ‘Resolution’ option. Press Right Direction key. Press Up or Down Direction key to select the required resolution from available options shown: 5 Megapixel, 3 Megapixel or 1.3 Megapixel. Press OK button to confirm the selection and press OK button to exit menu. Self Timer Press the Left direction key and a ’10 sec delay self timer’ icon will appear on LCD screen.
Taking photo with special effect 1. 2. 3. 4. 5. Press OK button to open the menu. Press Up or Down Direction key to select ‘Effect’ option. Press Right Direction key. Press Up or Down Direction key to select the required effect: Normal; B&W (Black and White); Sepia, Negative, Red, Green, Blue. Press OK button to confirm the selection and press OK button to exit the menu. 10. Playback mode: 1. Press / hold the Power key to turn the camera ON 2.
You can also Zoom In / Out displayed photo by pressing the Zoom keys. After Zooming In you may press Left or Right direction key to enter into the “Pan” mode and view selected area of the image. Press the OK button to resume normal preview.
Thumbnail mode • • In PLAYBACK mode, press Zoom Out Key to select the “Thumbnail” format. Press UP, DOWN, LEFT or RIGHT buttons to browse through images, then press OK (center button) to select image for an instant review. • Press Zoom In Key to enlarge and view image in full resolution. • Press Zoom Out Key to return to normal screen size and press same key again returning to “Thumbnail” format.
Adding the Voice memo for selected photo 1. Switch the camera to Playback mode. 2. Browse to the photo you wish to add voice memo. 3. Press OK button and select ‘Voice Memo’ option by pressing Up or Down Direction key 4. Press Right Direction key and enter sub-menu options 5. Scroll down and select the “Add” option; press OK key to confirm 6. Counter appears on the LCD screen and camera is ready for recording voice memo. 7. Speak your memo / message and the camera microphone will record the message. 8.
1 4 Playback mode icon 2 Image counter PHOTO file indicator 5 Playing time 6 3 Voice Memo indicator Control panel for playing voice memo Press the Shutter key to start playing the voice Memo of the photo (with added voice memo), or press OK key to stop playing. Use the UP key to pause / resume playing the voice Memo if desired. 11. Internal Setting of the camera 1. Press OK button; then press Right Direction key to enter the Internal Setup Menu (see the “tools” icon). 2.
taken image / photo as the Start-up Image. Format: Format the SD/MMC card (see Section 2: Using the SD Card). Reset all: Reset all the options to default values (manufacturer’s setting). Setting the Start-up Image: 1. Select Playback mode and select a photo to be set as the “Start-up Image” 2. Press OK key and use Up / Down keys to select ”Start-up Image” option and press OK key 3. Press Right Direction key and a sub-menu appears on LCD screen 4.
Off – Only the “blank” screen will be displayed during turning camera ON. System – The Default Image will be displayed as the Start-up Image My Image – Camera will use your selected photo as the Start-up Image. Note that if you select and execute the “Reset All” (from Internal Setting) option, this will also activate the Default Start-up Image according to manufacturer’s setting.
（If the screen does not appear as the auto-run, please click on SoftwareInstaller.exe under the CD-ROM drive icon on the computer.） Follow on-screen instructions and complete installation.
21
After installation, please restart the computer. 2. Using camera with the computer - Use the supplied USB cable and connect camera to the computer, open camera screen and turn the power ON. - Open “My Computer,” then select the Removable Disc. Usually, the highest nomination (indicated by alphabetic letters) of the Removable Disc will identify your connected camera. - Click open the Removable Disc then open the DCIM and 100MEDIA folder; this folder will contain all your video records and photos.
After starting MediaImpression, click “Import” to import the media.
Choose the video camera storage and choose the output location. Choose require file and click the import, selected file will be stored in the output location.
Click “Go to start page” to return the main screen, click the “Video” or “All media” to use the “YouTube” function. Choose file and click the “upload to YouTube”.
Enter your YouTube username and password to login and execute uploading video. Connecting camera toTV You may also display all photos and recorded video on typical TV set. 1. Use AV cable (supplied with camera) and connect camera with TV. 2. Plug single-connector of the cable into camcorder’s TV port, and connect double-connectors to Video (yellow) and Audio (red or white) input jacks of your TV. 3. Turn the TV and camera ON. 4. Select mode of your TV to VIDEO INPUT (see your TV Manual if it is required).
Technical Specifications Video resolution 720P: 1280x720 pixels, VGA: 640x480 pixels, QVGA: 320×240 pixels Picture resolution 1.3, Lens F3.1 f=6.5mm Focus settings Digital zoom Normal: 5 feet ~ infinity; 4× LCD display screen 1.
System requirements System Requirements Operating System Microsoft Windows XP, Vista, 7 Central Processing unit Intel Pentium III 1GHz or CPU of equal or higher performance Memory 512 MB or higher Sound Card, Display Card The sound card and the display card shall support DirectX8 or higher version. CD Driver 16 times speed or above Hard Disk Available space 1 GB or more Other One standard USB 1.1 or USB 2.
