User Manual

1. Charger the built-in lithium battery

Generally, it will OK to just connect the camera with a computer for charging the battery. At

this time, the charger indicator (blue) will light, and it will light off when being charged full.

It will generally take 2-4 hours to charge full. For faster charging full, you are

recommended to charge it in power-off.

2. Use storage card

2.1 Following instructions by the storage card slot, push in TF card into the slot till entirely

pushed in.

2.2 If to take TF card out, please gently press the end of the storage card inwards, and the

card will pop up.

Note: There is no built-in storage card available in the camera. It is a must to insert a

storage card in for using.

3. Power On/Of

3.1 Power-on: Press and hold POWER key for roughly 2 second, the screen will be

switched on and display a word “ON”, and the camera is powered on.

3.2 Power-off: when the camera is idle, press POWER key to power it off.

Automatic shutdown: When automatic time reached during the camera idle, it will

automatically shut down to save power. The default automatic shutdown time of the

system is 3 minutes.

3.3 Lower power shutdown: in case of a very low battery, LCD display will display an icon

“

”, and then the camera will be automatically shut down.

4. Mode Switch

Three modes are available, including Video mode, Photo mode and timelaps mode. You

can switch the mode by pressing the MODE key.

Video mode: For video recording;

Photo mode: For photo taking;

Timelaps mode: For taking time-lapse video

5 Video operation

When the camera is on, press MODE key to switch to video mode, as the following

picture shows, and press shutter button to start recording video; the LCD timer will start

counting the time automatically. Press the shutter button again to stop. If the memory is full

or in case of low battery, the recording will also stop automatically.

In this mode, press SET to switch between HI and LO:

HI indicates 1280x720@15FPS;

LO indicates 640x480@30FPS;