Specifications

TABLE 3·1. RECOMMENDED J1 CONNECTORS
TYPE OF CABLE
MANUFACTURER
CONNECTOR PIN CONTACT PIN
TWISTED PAIR, #18
AMP
(CRIMP OR SOLDER)
TWISTED PAIR, #18
VIKING
(SOLDER TERM.)
FLAT CABLE
3M "SCOTCH FLEX"
KEY SLOT ~ j.-- 0.036 ± 0.004
II (0091 ± 0010)
1
0.450 ± 0.010
(1.143 ± 0.025)
1·583718·1
3VH25/1 J N·5
3415·0001
i i
I I
~
~
~ f-0~~O,~?M
0.050 NOM 0.100 NOM--+-
(0.127) (0.254)
583616-5 (CRIMP)
583854-3 (SOLDER)
NA
NA
39216·16
,... ,... ... 50 ___ _
1...-....-0.063 (0.160)
r--- NOM (2X)
~~.-- _________ 2.575 ± 0.010 ---------.....-t
(6.541 :+ 0.025)
NOTE:
x.xxx ± x.xxx = in.
(x.xxx ± x.xxx) = em
3.3 J2/P2 CONNECTOR
BOARD THICKNESS 0.062 ± 0.007
(0.157 ± 0.017)
50574·19
FIGURE 3·2. J1 CONNECTOR DIMENSIONS
The dc power connector. J2. is mounted on the component side of the PCB and is located near the stepper motor.
J2 is a 5 pin AMP Mate-N-Lok connector PIN 1-350945-0. The recommended mating connector (P2) is AMP
PIN 1-480763 utilizing AMP pins PiN 350689-1. J2. pin 1. is labeled on the component side of the PCB. Figure
3-3 illustrates the J2 connector.
FIGURE 3·3. J2/P2 CONNECTOR
3·2