Product guide

11
Dipswitch setting for DMX Mode
DMX products must have their own "address" to receive DMX signals.
Addresses on the controller are set by flipping the appropriate DMX dip switches #1 - #9.
You need to know that DMX address settings are the sum of the dip switch values.
A standard DMX address for a Showtec Pulsator LED, which has 4 channels is as follow:
Example
Pulsator LED Address Value DMX Dip Switches "ON"
Unit 5 17 #1 , #5
Switch Value
#1 1
#5 16 +
Total sum 17
Explanation: Since each unit has 4 channels, each address advances 4 values (See Address Value
above).
Once address values are determined, add DMX dip switch values to obtain the appropriate address
(DMX Dip Switches "ON") for each unit. Flip appropriate DMX dip switches on each unit.
Example:
1. If you want to give a Pulsator LED DMX address 133, you first have to find the number 133 in the
DMX Chart. (See page 11)
2. Then look at the left side (Dip Switches #1-#5) horizontally from 133.
In the Table you’ll see #1=ON, #2=OFF, #3=ON, #4=OFF, #5=OFF.
3. Finally look at the upper side of the table (Dip Switches #6-#9) vertically from 133.
In the Table you’ll see #6=OFF, #7=OFF, #8=ON, #9=OFF.