Product guide

12
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit operates
properly, do not carry out following steps.
If the light effect does not operate properly, refer servicing to a technician.
1. If the device does not operate properly, unplug the device.
2. Check the fuse, power from the wall, all cables etc.
3. If all of the above appears to be O.K., plug the unit in again.
4. If you are unable to determine the cause of the problem, do not open the LED Club Scan, as this
may damage the unit and the warranty will become void.
5. Return the device to your Showtec dealer.
Product Specification
Model: Showtec LED Club Scan
Voltage: AC 230V-50Hz (CE)
Fuse: F 1 A, 250 V
Power consumption: 23 W
DMX-control-channels: 5
Sound-control: via built-in microphone
Flash-rate: 18 Hz
Number of LEDs: 40
Cooling: Ventilator
Dimensions: 380 x 190 x 255 mm (LxWxH)
Weight: 3,4 kg
Operation and Programming
DMX-control via standard DMX-controller
Signal pin OUT : pin 1 earth, pin 2 (-), pin 3 (+)
DMX Channels: 3
Signal input 3-pin XLR male
Signal output 3-pin XLR female
Maximum ambient temperature Ta: 45° C
Maximum housing temperature TB (steady state): 55° C
Min.distance from flammable surfaces: 0.5 m
Min.distance to lighted object: 0.1 m
Design and product specifications are subject to change without prior notice.
Website: www.Highlite.nl
Email: [e-mail]