Product guide

6
MENU DATA INSTRUCTION
CHA 0-599 Set DMX Address
TOP On / Off Set the turns of display
CE On / Off Set 4 or 20 channels
DBL On / Off Under „PAT“ Mode, set time for segmentto fade away
LSG 1 To 4 Set the Chase Speed
LSE On / Off Set MASTER and SLAVE. ON = SLAVE
SLO On / Off Choose time for FAST or SLOW fader
SOU On / Off Sound-activated switch
SS On / Off Fader Effect switch
GKN On / Off Special Display switch 1
BAK On / Off Special Display switch 2
DMX controlling: Only when it is set up as slave, it can receive signal from DMX or master. When M/S is
applied, the masters cannot be connected otherwise the signal will interfere.
Stand-alone Operation
Press the Blackout button to view the menu. Set Master to OFF. (LSE = OFF)
DMX Operation
Press the MODE button to view the DMX address setting rnenu:
The DMX Channel functions when using the entire device as one:
Channel 1: Red (0-255)
Channel 2: Green (0-255)
Channel 3: Blue (0-255)
Channel 4: Dimmer (0-255)
The DMX Channel functions when using the each section separately:
Section1 Channel 1: Red (0-255)
Channel 2: Green (0-255)
Channel 3: Blue (0-255)
Channel 4: Dimmer (0-255)
Section2 Channel 5: Red (0-255)
Channel 6: Green (0-255)
Channel 7: Blue (0-255)
Channel 8: Dimmer (0-255)
Etc….etc.
The LED Bar DMX’s built-in controller will automatically detect the presence of a DMX signal.
IF a DMX signal is present, the blue LED display will blink.
In order to receive a DMX signal, the built-in controller must be attached to a DMX controller by a 3-pin DMX
cable and the DMX controller must be turned on.
To mix RGB color for the first section use channels 1, 2, 3, and for dimmer use channel 4.