Product guide

7
Installation
Remove all packing materials from the LED Operator 1. Check that all foam and plastic padding is
removed. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Preset Mode
The LED Operator 1 has 9 built-in color macros.
1) Press the Preset button (2). The red LED above the Preset button lights up.
2) Now choose one of the 9 pre-programmed colors (1).
3) Adjust the Fade/Speed/Strobe/Green Fader (6) to set the desired Fade Time, when switching to
another color.
4) Adjust the Master Dimmer/Blue Fader (7) to set the desired dimmer level.
5) The Fade time and/or dimmer may now be readjusted. You can Press the strobe button (9) and then
use the Fade/Speed/Strobe Fader (6) to set the strobe speed.
Please make sure that the Strobe, Blackout and Manual RGB functions are not overriding the controls.
The Sound-control option will not function in Preset Mode.
Chase Mode
The LED Operator 1 has built-in color chases. There are several color combinations to choose from.
1) Press the CHASES button (3) . The orange LED above the Chases button lights up.
2) Adjust the Fade/Speed/Strobe/Green Fader (6) to set the desired Fade Time.
3) Adjust the Master Dimmer/Blue Fader (7) to set the desired dimmer level.
4) Use the Chases/Macro/Red Fader (5) to select one of the color combinations.
5) You can now readjust the Fade time and dimmer. Press the strobe button (9) and then use the
Fade/Speed/Strobe Fader (6) to set the strobe speed.
By moving the Chases/Macro/Red Fader (5), you can choose several built-in preset color chases.
Please make sure that the Strobe, Blackout, and Manual RGB functions are not overriding the controls.
The Sound-control option will work in Chase Mode.
Marco Mode
The LED Operator 1 has built-in color macros. This is a static color selection, so no chase movement or
color flows will occur. There are several color macros to choose from.
1) Press the Macro button (4) . The green LED above the Macro button lights up.
2) Adjust the Fade/Speed/Strobe/Green Fader (6) to set the desired Fade Time.
3) Adjust the Master Dimmer/Blue Fader (7) to set the desired dimmer level.
4) Use the Chases/Macro/Red Fader (5) to select one of the built-in color macros.
5) You can now readjust the Fade time and dimmer.
Please make sure that the Strobe, Blackout, and Manual RGB functions are not overriding the controls.
The Sound-control option will not function in Macro Mode.