Product guide

9
Maintenance
The Showtec LED Operator 1 requires almost no maintenance. However, you should keep the unit clean.
Disconnect the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in
liquid. Do not use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the DMX and audio connections
with a damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying
electric power.
Troubleshooting
Showtec LED Operator 1
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
1. Fixture does not respond to controller: Check the DMX-address of the fixture and the controller.
Make sure they match. Make sure the connections are correct.
2. Interference between chases; If the same channel is assigned to different running chases, the one
with the highest channel value will be put out.
3. If the device does not operate properly, unplug the device.
4. Check power from the wall, all cables, the settings, etc.
5. If all of the above appears to be O.K., plug the unit in again.
6. If nothing happens after 30 seconds, unplug the device.
7. Return the device to your Showtec dealer.
Product Specification
Model: Showtec LED Operator 1
Power supply: AC 12V- 1A
Power consumption: 6 Watt
Power connector: Adapter (included)
Easy to use
Control RGB fixtures
Adjustable Speed control
Adjustable fade time
Total DMX Channels: 3
DMX-512: XLR 3 pole
Strobe Function
Individual RGB Channel Faders
Grand Master Fader
Speed fader for Chase control
Strobe
Dimensions : 210 x 140 x 50 mm (LxWxH)
Weight : 0,88 kg
Design and product specifications are subject to change without prior notice.
Website: www.Showtec.info
Email: [e-mail]