Product guide

7
Control Modes
One Star LED (Manual Control)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. When the Star LED is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 12 for more information about the manual control mode.
One Star LED (Sound-control)
1.Plug the end of the electric mains power cord into a proper electric power supply socket.
2. Turn on the music. If device is set to (Audio) and you have pressed enter, then the fixture will
react to the beat of the music. Please see page 13 for more information about the sound-control
options.
Multiple Star LEDs (Master/Slave control)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the Star LED.
The pins:
1. Earth
2. Signal -
3. Signal +
3. Link the units as shown in (Fig. 2), Connect a DMX signal cable from the first unit's DMX "out"
socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page 7 (Manual control or
Music control). This means on the master device you can set your desired operation Mode
and all slave devices will react the same as the master device.
Multiple Star LEDs (Master/Slave control)
Fig. 2