User manual

Ordercode: 50756

Single WDP-1

Main Menu Options

1. Remote control/Manual control

2. DMX Addressing (Fun1)

3. Dimmer/Switch (Fun1)

4. Dimmer Limit (Fun1)

5. WDP Control (Fun1)

6. Dimmer Preset (Fun2)

7. Full On (Fun2)

1. Remote Control/Manual Control

01) Press the MENU button until the display shows or .

02) Press the UP/DOWN buttons to choose between (DMX/wireless DMX receiver enabled) and

(manual mode).

Note:

If you have chosen , please read sections 2-5.

If you have chosen , please read sections 6-7.

2. DMX Addressing (Fun1)

01) Press the MENU button until the display shows .

02) Press the UP/DOWN buttons to choose the desired DMX address.

The adjustment range is between 001-512. Press and hold down the UP/DOWN buttons for fast DMX

address selection.

03) The currently selected DMX address will be automatically saved.

3. Dimmer/Switch (Fun1)

01) Press the MENU button until the display shows .

02) Press the UP/DOWN buttons to choose between and .

03) If set to , then it is possible to remotely dim the light output.

04) If set to , then it is possible to switch the light output on/off.

4. Dimmer Limit (Fun1)

01) Press the MENU button until the display shows .

02) Press the UP/DOWN buttons to set the desired maximum dimming limit value. The adjustment range is

between 0-100.

5. WDP Control (Fun1)

01) Press the MENU button until the display shows .

02) Press the UP/DOWN buttons to choose between (controlled by XLR DMX) and

(controlled by wireless DMX).

6. Dimmer Preset (Fun2)

01) Once you have set the device to (see section 1 above), press the MENU button.

02) The display will show .

03) Press the UP/DOWN buttons to set the desired dimmer value. The adjustment range is between 0-100,

from dark to brightest.