Product guide

JOYSTICK / CHANNEL SELECTION

Set-up Joystick

1) Press and hold the PROGRAM button, until the LED is lit.

2) Press and hold the MODE and FINE button at the same time, the assign LED should light. If the reverse

LED lights, press FINE and MODE again to enter assign mode.

3) Use the BANK up and down keys to select the axis you wish to assign (Pan or TILT).

4) Use the "TAP/DISPLAY button to select a 16 or 8 channel mode.

5) Press the button corresponding to the scanner you wish to assign.

6) While holding the MODE button, press the scene number corresponding to the slider which controls the

movement. (Example: If pan is controlled by slider number 4, press and hold the MODE button while

tapping scene button 4#).

7) When finished press the FINE and MODE buttons at the same time again to exit Assign mode.

Reverse Joystick Movement / DMX Channel

1) Enable Programming Mode.

2) Press the FINE and MODE buttons to enter assign mode, then press FINE and MODE buttons again to

enter reverse mode. The reverse LED lights up, indicating reverse mode is active.

3) Use BANK Up/Down button to change between the Pan and Tilt, the corresponding LED lights, indicating

this selection.

4) Press the Tap/Display button to change between the 8 Channel or 16 Channel mode.

5) Press the SCANNER button to select the scanner.

6) While holding the MODE button, press the corresponding SCENE button for the channel you wish to

reverse. (For Example: If you are reversing the one scanner, once you verify that you are in reverse

mode, and the Tilt LED is lit, check to see which slider the Tilt control is on. Hold the MODE button and

press the SCENE button, that is same as the slider number for tilt. (Slider 5/Scene 5).

7) Continue steps 3-7 as needed. You may reverse a maximum of 48 channels for 12 scanners.

Delete a Scanner of DMX Channels

1) Activate Assign or reverse mode.

2) Tap the SCANNER button to select the scanner you wish to delete.

3) Press the MODE and Auto/Del buttons at the same time". All LEDs will flash three times, indicating the

requested operation has been performed.

Clear All DMX Channels

1) Turn the unit’s power off.

2) Press the MODE and Auto/Del buttons at the same time.

3) While holding the two buttons, turn the power back on. All LEDs will flash briefly, indicating the requested

operation has been performed.

Display DMX Channel

1) Press the FINE and MODE buttons at the same time, putting the controller into assign mode.

2) Press the FINE and MODE buttons again, lighting the reverse LED.

3) Press the SCANNER button that is set at the desired Pan and Tilt, and the LCD will display the DMX

values for Pan and Tilt.