Product guide
11
CHASES
Programming a Chase
Note: You must have already programmed scenes in order to program a chase. This function allows you to
cycle through up to 240 scenes in a preselected order. It is recommended to delete all chases in the
controller, before programming chases for the first time. Also see Delete All Chases for instructions.
1) Enable Programming Mode.
2) Tap the CHASE button to select the chase you wish to program.
3) Select a desired scene from the bank that has scenes stored inside it.
4) Tap the MIDI/Rec button.
5) Repeat steps 3-4, until all desired scenes scenes have been entered.
Inserting a Bank of Scenes into a Chase
1) Enable Programming Mode.
2) Select the chase you wish to program.
3) Use the BANK Up/Down key to select the bank of scenes you wish to copy.
4) Tap the Music/Bank Copy button.
5) Tap the MIDI/Rec copy button, all LEDs will flash three times, indicating that the requested operation has
been performed.
Adding a Step
1) Enable Programming Mode.
2) Press the corresponding button, to add a step to the chase you wish.
3) Press the Tap/Display button, the LCD will show the current step.
4) Press the BANK Up/Down button and scroll to the step you wish to insert the step after.
5) Press the MIDI/Rec button, the segment display will read the step one step higher than before.
6) Tap the Tap/Display button again. The LCD shows the current chase, scene, and bank. Create a desired
scene and record it as a new step or select a previously programmed scene to add to the chase.
7) Once you have selected the scene you wish to add, press the MIDI/Rec button again. All LEDs will flash
three times, indicating the new step has been inserted into the chase.
Delete a Step
1) Enable Programming Mode.
2) Select the chase, which contains the step you wish to delete.
3) Press the Tap/Display button, the LCD shows the current step.
4) Press the BANK Up/Down button and scroll to the step you wish to delete.
5) Press the Auto/Del button to delete the step. All LEDs will flash three times indicating the requested
operation has been performed.
Delete a Chase
1) Press the corresponding button, to delete the chase you wish.
2) Press and hold down the Auto/Del button while holding down the CHASE button. All LEDs will flash three
times, indicating that the requested operation has been performed.
Delete All Chases
1) Turn the unit’s power off, press and hold down the Auto/Del and BANK Down buttons at the same time.
2) Re-apply the power, and all chases should be cleared.