Product guide

8
Procedure :
1. Loosen the 2 screws on the front of the housing where the lamp is damaged/broken.
2. Gently remove the small metal front plate.
3. Read lamp instructions.
4. Insert the lamp into the small E27 screw socket.
5. Put the lamp cover back and fasten the screws snugly.
Fig. 3
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
One / Multiple Matrix Blinder(s) DMX Control
1. Fasten the effect light onto firm trussing. Leave at least 1 meter on all sides for air circulation.
2. Use a 3-p or 5-p XLR cable to connect the Matrix Blinders and other devices.
3. Link the units as shown in (figure 4), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
4. Supply electric power: Plug electric mains power cords into each unit's Powercon socket, then plug the
other end of the mains power cord into proper electric power supply sockets, starting with the first unit.
Do not supply power before the whole system is set up and connected properly.