User manual

6
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
2.1 Mode Select
Press and hold down F button first, tap the Signal Select
button causing the Segment Display shows "IN", DMX
LED lights indicating DMX mode is active, this unit
serves as a 4 channel DMX dimmer pack.
While holding down F button, tap Signal Select button,
when the Segment Display shows "OUT", Master LED
lights indicating Master mode is active, this unit serves
as a 4 channel DMX chaser when linkup use.
2.2 DMX-Mode
When the Segment Display shows "IN" and the DMX LED lights, this unit serves as a 4 channel DMX
dimmer pack. The DMX Signal LED blinks when DMX signal is present.
1. Tap the channel button, the corresponding channel
LED blinks indicating your selection and the Segment
Display shows the DMX address of last time.
2. Tap the Up/Down button to select your desired
DMX address from 001 to 512.
3. Once you've set the DMX address, tap the channel
button a second time to store your setting into
memory.
4. Continue steps 1-3 until you've set all 4 channels.