www.prolight.co.
LEDJ PAR CAN 56 SAFETY WARNING FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! CAUTION! Keep this equipment away from rain, moisture and liquids.
LEDJ PAR CAN 56 SAFETY IMPORTANT: The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any unauthorised modification to the equipment. • Never let the power-cable come into contact with other cables. Handle the power-cable and all mains voltage connections with particular caution! • Never remove warning or informative labels from the equipment. • Do not open the equipment and do not modify the equipment.
LEDJ PAR CAN 56 INTRODUCTION Introduction CONTROL FEATURES • 4-channel DMX-512 LED Par Can • Blackout/Dimmer/Strobe/sound activation • Individual control of Red, Green and Blue LED’s Features • 108 LED’s: - Red (36), Green (36), and Blue (36) • Ultra bright 10mm LED’s • RGB colour mixing • Built-in colour change programs • Low power consumption • Up to 100,000-hour LED life span • Master/Slave mode • Programmable: Any universal DMX-512 controller OPTIONS DMX Channel Summary Channel Function 1 RED 0
LEDJ PAR CAN 56 OVERVIEW Product Overview Setup Operating Instructions The LED-56 is a DMX-512 controllable, full RGB colour mixing Par Can made up of high efficiency and super bright LED’s. There are three colour groups (red, blue and green) whose intensity can be controlled individually allowing the creation of an unlimited range of colours. The LED-56 will operate in stand-alone, Master/Slave, sound activated and via DMX-512 control.
LEDJ PAR CAN 56 MASTER/SLAVE Master/Slave The Master/Slave mode will allow you to link up as many units as you want in a daisy chain fashion. In this mode, the first unit in the daisy chain will control the following units. 1) Connect all units in a daisy chain as described in the section following.
LEDJ PAR CAN 56 CONTROL OPTIONS Manual Control Options Colour Selection • With Dip Switch 1 only set to ON you obtain static RED • With Dip Switch 2 only set to ON you obtain static GREEN • With Dip Switch 3 only set to ON you obtain static BLUE You can have any combination of switches 1,2,3 to obtain static colour mix. Flashing Mode Once you have selected a static colour you can make it flash by using Dip Switches 4,5,6, 4 is slow flash, 4&5 is medium flash and 4,5 & 6 is fast flash.
LEDJ PAR CAN 56 CONTROL OPTIONS DMX Control Mode Set the start address using the group of dip switches located usually on the back of the fixture. Each dipswitch has an associated value. Adding the value of each switch in the ON position will provide the start address. Determining which switches to toggle ON given a specific start address can be accomplished in the following manner. By subtracting the largest switch value possible from the selected start address until zero is achieved.
LEDJ PAR CAN 56 DMX SET UP DMX-512: • DMX (Digital Multiplex) is a universal protocol used as a form of communication between intelligent fixtures and controllers. A DMX controller sends DMX data instructions form the controller to the fixture. DMX data is sent as serial data that travels from fixture to fixture via the DATA “IN” and DATA “OUT” XLR terminals located on all DMX fixtures (most controllers only have a data “out” terminal).
LEDJ PAR CAN 56 DMX SET UP Notice: • Be sure to follow figures 2 & 3 when making your own cables. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in contact with the XLR’s outer casing. Grounding the shield could cause a short circuit and erratic behaviour. Special Note: Line termination: • When longer runs of cable are used, you may need to use a terminator on the last unit to avoid erratic behaviour.
LEDJ PAR CAN 56 Dip Switch Reference Chart DMX Dip Switch Quick Reference Chart Dip Switch Position
LEDJ PAR CAN 56 DMX VALUES DMX Channel Values Default VALUE Function 1 000>255 RED 0-100% 2 000>255 Green 0-100% 3 000>255 Blue 0-100% Shutter/Strobe/Dimmer 4 000 001<>189 190<>250 251<>255 Blackout: 000 Intensity: 001<>189 Strobe: 190<>250 Full on: 251<>255 Technical Specifications Weight & Dimensions • Length…...........................................................275mm • Width................................................................230mm • Height……………………………………………..
