Product guide

4.6 Delete a Step from an existing Chase

1. Press and hold down the the Record button (15) for 3 seconds to enter Record Mode.

2. The red LED next to the button lights up.

3. Select the chase from which you want to delete a step.

4. Use the Mode/Up (19) and Patch/Down buttons (20) to scroll through the chase and select the step

you want to delete.

5. Push the Tap Sync button (16) to delete the step.

6. All LEDs will flash 3 times, indicating the step has been successfully deleted.

7. Continue this procedure (steps 3, 4 and 5) if you want to delete multiple steps. If you are finished

deleting the steps, press the Record button (15) to exit Record Mode.

4.7 Manual/Auto / Music Mode

Manual

1. Press the Mode button (19) until the LED in front of Manual (number 1)lights up green.

2. With Tap Sync you can manually go through the chase steps.

Fade Time (16) is available in Manual Mode

Auto

1. Press the Mode button (19) until the LED in front of Auto (number 2) lights up green.

2. You can control the Speed and Fade Time by adjusting the Speed and Fade Time fader (22+23).

Music

1. Press the Mode button (19) until the LED in front of Music (number 3) lights up green.

2. You can control the Audio sensitivity by adjusting the Audio fader (21).

Fade Time is available in Music Mode

The LED Commander Pro can be used as a plug-and-play device with the following Showtec products:

42431 Par 64 Short, RGB LED

42432 Par 64 Short, RGB LED

42421 Par 56 Short, RGB LED

42422 Par 56 Short, RGB LED

42400 LED Pinspot

42401 LED Pinspot

42410 Par 36 Short, RGB LED

42411 Par 36 Short, RGB LED

42460 LED RGB Par 64 High Power 18 x 3W

42461 LED RGB Par 64 High Power 18 x 3W

42435 LED Par 64, 24 x 1W

42436 LED Par 64, 24 x 1W