User manual

00026099.DOC, Version 2.2
17/35
Auto Mode
In this mode, automatic program flow can be set.
Set DIP-Swich 9 and 10 to OFF.
Set DIP-Swiches 1 through 4 to OFF.
Speed can be controlled by setting the DIP-Swiches 5 and 6.
Flash can be controlled by setting the DIP-Swiches 7 and 8.
Sound Control Mode
In this mode, sound control mode can be set.
Set DIP-Swich 9 to ON and 10 to OFF.
Sensitivity can be controlled by setting DIP-Swiches 1 through 4.
Slave Mode
In this mode, you can select and set the slave devices.
Set DIP-Switch 10 to ON in order to determine the Slave device.
DIP-Swiches 1 – 9 are on OFF.
DMX-CONTROLLED OPERATION
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features.
Addressing the Device
Set the DIP-Switch 10 to ON.
Set the DMX Addresses via DIP-Switches 1 through 9.
Controlling:
After having addressed the LED Bar RGB 252/10 Indoor, you may now start operating it via your lighting
controller.
Note:
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.