Product guide

8) Audio sensitivity

Used to adjust the input sensitivity of the external audio inputs. Adjust the level until the sound activated

functions work nicely to the rythm of the music.

9) Dimmer channels

These are 4 faders used to set the individual dimming levels of the 4 channels. Below each fader there's a

flash button to set the output of the corresponding channel to 100% (full) for as long as the button is

pressed.

10) Program display

Shows which of the 4 modes is currently active.

11) Mode select

Used to select 1 of the 4 user modes:

Hold Dim: This mode can be used to control the dimming levels of the outputs. The 4 faders can be used

to set the dimming level of each channell output individually.

Hold Sound: The Music is divided into 4 different frequency ranges (bass, middle, high, antibass). Each of

the 4 output channels will respond to a different frequency range.

Program Sound: The chaser program selected with the "program select" button will be displayed. The

chaser speed is synchronised to the rythm of the music.

Program Speed: The chaser program selected with the "program select" button will be displayed. The

chaser speed can be adapted with the speed fader.

12) Program select

When you have selected 1 of the 2 program modes then you can use the program select button to

choose the program you like. Nine different chaser programs can be selected. Program 0 is a random

program.

13) Full switch

Use this button to set the output of the 4 channels to 100% (full) for as long as the button is pressed.

14) Standby switch

Used to cutoff (blackout) the output of the 4 dimmer channels. The 4 switch channels are not affected.

15) Speed X10

Used to multiply/divide the speed set by the speed fader by 10.

Controller Backside

Fig. 2

16) Analog output

Use this output to connect an additional analog dimmer pack (ie. Showtec Dim-master 6, D-pack 6)

17) DMX output

Use to connect the LP-416 to DMX power packs. All 4 channels are are available on this output. The

dimmer channels are assigned to DMX addresses 001 to 005. Please set the starting address of the

connected dimmer pack to 001.

18) Channel fuses

Each channel has it's own fuse. Always replace a blown fuse with a fuse that has the same ratings

(F8A 250V 6x32mm).