User manual

Multiple Movingheads DMX Set Up

Fig. 3

Note : Link all cables before connecting electric power

Controlling:

After having addressed all the fixtures, you may now start operating these via your lighting controller.

If there is no data received at the DMX-input, the problem may be:

• The XLR cable from the controller is not connected with the input of the first fixture.

• The controller is switched off or defective, the cable or connector is detective, or the signal wires are

swapped in the input connector.

Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure

proper transmission on the DMX data link.